DREAVER S340 Podręcznik użytkownika - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Bieżnia DREAVER S340. DREAVER S340 12 stron.

MAINTENANCE

1. Lubrication

After using the running belt for a period of time, it is necessary to use special belt oil for

belt sliding. The recommended lubrication time is:

Lubricating once every 5 months for usage of less than 3 hours per week. Lubricating once

every 2 months for usage of 4-7 hours per week.

Lubricating once every month for usage of more than 7 hours per week. Note: do not use

too much each time.

2. Check whether lubrication is required

Grasp the running belt, and touch the back, of the running belt, as close to the central area

as possible. If there is silicone oil on the belt (or it feels a little wet), it means no

lubrication is needed. If you feel that the running board is dry and there is no silicone oil

on your hand, you need to add oil and lubricate the belt.

Measure the center position of the running belt (refer to the right figure) and spray

silicone oil on the inside of the running belt. After that, run the treadmill at a speed of 1km

to evenly smear silicone oil, and light the running belt from left to right . After about a

minute, the silicone oil will be absorbed by the running belt.

3. Elastic adjustment of running belt

All treadmills have the running belt's tension adjusted before they leave the factory, but

after a period of use, the running belt will become looser. The specific form of expression

is: running in normal use with a stop slip phenomenon. When this happens, adjust the

running belt adjusting both left and right synchronously according to the clockwise

direction with half a circle as the unit.

Note: When adjusting the

running belt, it is not advised

to adjust the running belt

too tightly, which shall be subject to

the normal use of the running belt

without slipping. If the running belt is

adjusted too tightly, the aging of the

running belt will be accelerated, the

motor load will be increased, and the

service life of the bearing will be

shortened.

D REAVE R - TREA DM IL L