Comnet CLFE16UTP Instrukcja instalacji i obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Przedłużacz Comnet CLFE16UTP. Comnet CLFE16UTP 9 stron. Ethernet-over-utp/twisted pair extender with pass-through poe
Drukuj stronęINSTALLATION AND OPERATION MANUAL
Pass-ThRoUGh PoE oPERaTIoNs FoR ThE CLFE1UTP
ComNet's CopperLine CLFE1UTP extended distance IP data and PoE maintains the safety standards for communications found
within the 802.3af PoE standards. This is for the protection of products operating in the extended distance transmission chain. In the
event of malfunctions the communication system is designed to shut down power transmission to avoid device damage.
The CLFE1UTP can be powered by a local power source (12 Volts D.C. or 24 Volts A.C.) or from a single PSE source, such as a
network switch's PoE port using its unique Pass-through PoE feature (4-pair mode only). This latter feature eliminates the need for
CLFE1UTP local power while also providing power for the camera (See full installation instructions, Page 6).
Powering The CLFE1UTP Transceivers
Input with
external power
plug installed.
Under normal operating conditions CLFE1UTP transceivers should be powered using the PoE source. External power to the
CLFE1UTP should be restricted to installations where a camera requires local power.
When installing the CLFE1UTP, the following conditions apply which will affect its operations.
The CLFE1UTP is provided with the ability to operate using a local external power supply. The standard accessory local power
adaptor plug can be used for power supplies that do not have the CLFE1UTP's standard power input connector. When inserting
the adaptor into the power input, the CLFE1UTP is only powered from a local power source and not from a PSE source. The camera
will continue receiving power from the PSE source and operations will be normal.
However, if the external plug adaptor is inserted in the CLFE1UTP and no power is applied, the CLFE1UTP will not power up even
if a PoE source is present, the camera will continue to receive power. In this case the CLFE1UTP is not operational and no data will
flow.
If the CLFE1UTP is externally powered and PsE power is lost, power to the CLFE1UTP must be recycled in order for the PsE to
recognize the PD (Camera).
TECh SUPPORT: 1.888.678.9427
CLFE(X)UTP
External
power adapter
(included)
INS_CLFEXUTP_REV–
09/28/11
PAGE 3