Comnet FDX72M1 Instrukcja instalacji i obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Transceiver Comnet FDX72M1. Comnet FDX72M1 6 stron. Multi-protocol rs232/422/485 data transceiver featuring linear drop-insert-repeat
INSTALLATION AND OPERATION MANUAL
FIGURE 6 – DATA CONNECTIONS
Equipment
Data Transmit
Data Receive
RS232
Signal Ground
Data Out (+)
Data Out (–)
RS422
Data In (+)
Data Out (+)
Bi-phase or
Manchester
Data Out (–)
2-Wire
RS485,
Sensornet
Data Out (A)
Data Out (B)
4-Wire
RS485
FIGURE 7 – 7-PIN DATA CONNECTOR
FIGURE 8 – LED INDICATORS
lINK A
lINK B
GREEN
unit In Sync
unit In Sync
RED
unit Not In Sync
unit Not In Sync
oFF
–
–
TEch SUPPORT: 1.888.678.9427
Customer
DOUT(–)
DOUT(+)
Data In (–)
DOUT(–)
Data (A)
Data (B)
Data In (A)
DOUT(+)
Data In (B)
DOUT(–)
BIAS
ALARM
GND:
DIN+/DIN-
DOUT+/DOUT- Electrical data outputs. See Figure 6 for data connections.
DIN
Data Activity
–
No Data Activity
FDX72
DIN(–)
GND
DIN(+)
DIN(–)
DIN(+)
DIN(–)
DIN(+)
DIN(–)
DIN(+)
DIN(–)
Current limited +5V connection. This terminal can be used as a
connection for pull-up resistors, if required.
Alarm relay output. Indicates fault conditions. The relay is internally
connected to the GND terminal when no faults are detected (i.e.
a normally closed relay). The relay circuit opens when a fault is
detected anywhere in the system.
Signal ground reference. This terminal can be also be used as a
connection for pull-down resistors, if required.
Electrical data inputs. See Figure 6 for data connections.
Dout
StAtuS
Data Activity
System oK. No Alarm
–
Fault Detected. Alarm condition.
No Data Activity
–
FDX72(M,S)1
Customer
FDX72
Equipment
DOUT(–)
Data Receive
DIN(–)
Data Transmit
GND
Signal Ground
DOUT(+)
Data In (+)
DOUT(–)
Data In (–)
DIN(+)
Data Out (+)
DIN(–)
Data Out (–)
DOUT(+)
Data In (+)
DOUT(–)
Data In (–)
DIN(+)
Data (A)
DIN(–)
Data (B)
DOUT(+)
Data In (A)
DOUT(–)
Data In (B)
DIN(+)
Data Out (A)
DIN(–)
Data Out (B)
PoWER
unit Powered up
–
unit Powered Down
INS_FDX72_REV–
02/29/12
PAGE 4