Electrolux EGG 689 Instrukcja obsługi - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Hob Electrolux EGG 689. Electrolux EGG 689 16 stron. Gas hob
Również dla Electrolux EGG 689: Instrukcja obsługi (16 strony), Instrukcja obsługi (16 strony)

Drukuj stronę

Cut Out Size

The dimensions of the cut-out are given in the diagram.

FO 2098

Building In

Building over a cupboard or

drawer

If the hob is to be installed above a cupboard or drawer it

will be necessary to fit a heat resistant board below the

base of the hob on the underside of the work surface.

It is also recommended to carry out the electrical

connection to the hob as shown in diagrams 1 and 2.

Building over a kitchen unit with

door

Proper arrangements must be taken in designing the

furniture unit, in order to avoid any contact with the bottom

of the hob which can be heated when it is operated. The

recommended solution is shown in diagram 3.

The panel fitted under the hob ("a") should be easily

removable to allow easy access if technical assistance

is needed. The space behind the kitchen unit ("b") can

be used for connections.

Fitting the hob to the worktop

Before fitting the hob into the cut out, an adhesive seal

must be fitted to the underside outside edge of the hob.

It is essential that no gaps are left in this seal in order to

prevent spillage near the hob seeping into the cabinet

below.

1) Remove the pan supports, the burners caps and

crowns and turn the hob upside down, taking care

the ignition candles are not damaged in this

operation.

2) Place the relevant sealing all around the glass

top edge, taking care that the sealings meet

without overlapping (Fig. 4).

3) Place the hob in the cut out, taking care of its

centring.

4) Fix the hob with the relevant screws (Fig. 5).

FO 0764

Dimensions are given in mm.

FO 2108

a) Sealing gasket

FO 0763

FO 1013