Dremel 5000231 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Dremel 5000231. Dremel 5000231 9 stron. Shaper/router table

Drukuj stronę

Installing Router Bits

1. When installing router bits, be sure the

power cord is unplugged, then remove

the tool from the Shaper/Router Table.

Fit the ROUTER BIT SHANK into the

collet allowing a maximum of 5/8" to

protrude past the collet nut. Use the

spindle lock and wrench to secure the

bit. (See Fig. 3)

2. Loosen the WING NUT on HEIGHT

STAND

and

ADJUSTING SCREW to set cutting

depth. Depth of cut will be the amount

the

bit

extends

SHAPER/ROUTER TABLE. After

setting cutting depth, retighten wing nut.

Cutting Depth Adjustment

Adjustment markings on the back of

adjusting bracket are marked in inches and

millimeters. Each line on the fractional side

represents 1/16 of an inch. Each line on the

metric side represents one millimeter. View

the markings prior to starting your project.

Loosen the clamp knob and turn the

adjusting screw counterclockwise (lowering

the adjusting bracket), set to desired depth

and tighten clamp knob. To insure proper

settings, rout and measure cut on scrap

material.

Router Feed Direction

The router spindle turns in a counter

clockwise direction when viewed from

above the table. For best control and quality

of cut, feed the work into the bit in the

direction that the bit will tend to pull the

work to the fence. (Incorrect feed direction

will result in the bit trying to pull the wood

thru faster than you want.) Feed the

workpiece from right to left as shown. Feed

direction is extremely important when using

a pilot bit freehand on the edge of a

workpiece as well as when using the fence

with all bits. (See Fig. 4)

turn

the

DEPTH

above

Fig. 3

HEIGHT

STAND

WING NUT

the

DEPTH

ADJUSTING

SCREW

Fig. 4

ROUT

END

GRAINS

FIRST

Feed directions for outside and inside routing.

Note the sequence of the cuts for routing around

all four edges of a rectangle or square board.

-5-

ROUTER BIT

ROUTER FEED DIRECTION

BIT ROTATION

DEPTH

OF CUT

TABLE

SMALL CLAMP

LARGE CLAMP