Dremel 3D20 Idea Builder Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarki 3D Dremel 3D20 Idea Builder. Dremel 3D20 Idea Builder 4 stron. Unclogging
Również dla Dremel 3D20 Idea Builder: Skrócona instrukcja obsługi (8 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (8 strony), Skrócona instrukcja obsługi (4 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja rozwiązywania problemów (2 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (2 strony), Skrócona instrukcja obsługi (2 strony)

Dremel 3D20 Idea Builder Skrócona instrukcja obsługi
Step 12: All wires should be
disconnected. Move the turbo fan
and bracket out of the way.
Step 13: Unscrew the extruder
mounting screws from underneath
the extruder assembly. There are 2
screws, one located on the right
side and one located on the left
side.
Step 14: Remove the extruder
assembly.
Step 15: Replace the new extruder
assembly onto the extruder
carriage.
Step 16: Insert and tighten both
screws, left and right, to secure
extruder assembly to the extruder
carriage.
Step 17: Reconnect the fan wire
connector. This connector is
marked with black ink. (Red and
black to red and black wires).
Step 18: Reconnect the heat
cartridge wire connector.
(Orange and blue wire to 2 white
wires).
Step19: Reconnect the
thermocouple wire connector.
(Red and blue to red and white
wires).