andover SPINSTAND Instrukcja montażu - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Stojaki i stojaki andover SPINSTAND. andover SPINSTAND 11 stron. Component & record rack

Assembly - Cont.

12. Slide the Middle Shelf (Item 3) over the

threaded rods making sure the edge

with the wider spacing between the

holes and edge is towards the front, just

as you did with the Top Shelf. The shelf

should be oriended with the top down.

The Record Stop should be facing down

and along the back.

13.

Slide the remaining Long Pillars (Item

Wide

6) over each rod assembly and carefully

Spacing

align each pillar in the square recess cut

in the shelf.

14. Slide the Base Shelf (Item 4) in position

over the four rods. The Label should be

facing up and towards the rear of the

shelf.

15. Place a Washer (Item 10) on each rod,

followed by a Hex Nut (Item 11 ). Snug it

up but don't tighten it.

16. Carefully align each Pillar such that they

fit securely into the mating recesses in

the shelves. Once everything is aligned,

tighten the nuts firmly using the suppled

wrench (Item 25). Hold the panel nuts

(Item 7) with the Allen Wrench (Item

19). Important: Make sure all the pillars

are correctly aligned with the square

pockets in the shelves or the stand will

be uneven.

17. Slip a spacer (Item 9) over each rod,

then screw a foot (Item 12) over each

rod and twist it finger-tight against the

spacer.

Page 8