3M 3MDW101 Instrukcja instalacji i obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Systemy filtracji wody 3M 3MDW101. 3M 3MDW101 8 stron. Drinking water system

Drukuj stronę

DRINKING WATER FAUCET INSTALLATION

To reduce the risk of eye injury while drilling countertop for faucet installations:

• Safety glasses MUST be worn during the sink hole drilling operations.

•

The drinking water system faucet should be located on a ﬂ at surface, conveniently located near the sink, so that it

empties into the sink. Most sinks have pre-drilled holes designated for sprayers, soap dispensers, and other ac-

cessories. If your sink does not have an extra hole, we highly recommend professional installation.

•

Porcelain, enamel, and ceramic sinks require special procedures for drilling holes. Professional installation is

highly recommended. (See page 6)

Drilling 9/16" diameter hole through countertop or stainless steel sink:

1. Locate area to be drilled. Mark center of hole with center punch.

2. Drill hole with 9/16" drill bit suitable for countertop materials or cast iron/stainless steel.

3. With grinding wheel or ﬁ le,

smooth out any rough edges.

Installing the faucet:

1. Slide the following parts in the

order speciﬁ ed up blue tubing and

threaded stem:

a. Metal bezel

b. Large rubber washer

2. Next, feed blue tubing and faucet

stem down through faucet mount-

ing hole.

3. From underneath sink, assemble

the black spacer, star washer,

and hex nut (as shown) onto the

threaded stem and tighten by hand.

4. With a padded adjustable wrench,

turn the faucet base (above the

counter) to the right to securely

fasten. Raise faucet handle and

remove plastic shipping tube from

base.

5. Insert faucet neck onto base until

seated and align over sink. Lower

faucet handle.

IMPORTANT: INSTALLATION INSTRUCTIONS

For Use With Cold Water Only.

NOTE: Remove items from under the sink. Place catch basin under cold water faucet stem to collect small amounts of

water that may run out when disconnecting water supply lines.

1. Open faucet and turn off cold water supply valve and

remove existing water supply tubing and/or ﬁ tting.

2. Select and mark a location for the system under the sink

that allows access for replacement ﬁ lter changeout and

convenient hook up to the tubing attached faucet.

NOTE: 1/4" union adapter along with segment of 36" long

tubing can be used to extend tubing attached faucet.

3. Using Filter Head Assembly as a guide, fasten Filter Head

Assembly to wall with 2 Phillips mounting screws supplied.

Mark hole locations so that there is 1 1/2" between the

screws (see Figure 2), from center of each screw. When

installed, ﬁ lter bottom should be at least 2 1/2" from sink

cabinet ﬂ oor to facilitate ﬁ lter change. Install screws, but

only halfway, so you can easily slip the bracket to wall

before ﬁ rmly setting screws.

CAUTION

IMPORTANT NOTES

Shipping Tube

Metal Bezel

Rubber Washer

Shipping Tube

Metal Bezel

Rubber Washer

Countertop

Plastic Backing Spacer

Star Washer

Hex Nut

Shipping Tube

Metal Bezel

Rubber Washer

Countertop

Metal Bezel

Rubber Washer

Countertop

4, 5

Plastic Backing Spacer

Star Washer

Hex Nut

OUTLET

INLET

Figure 2

Installed

Figure 1