Electrolux 30" Electric/Microwave Combination Wall Oven Instrukcja instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Okap wentylacyjny Electrolux 30" Electric/Microwave Combination Wall Oven. Electrolux 30" Electric/Microwave Combination Wall Oven 21 stron. Gas cooktop
Również dla Electrolux 30" Electric/Microwave Combination Wall Oven: Instrukcja instalacji (16 strony), Instrukcja instalacji, użytkowania i konserwacji (22 strony), Instrukcja instalacji (28 strony), Instrukcja obsługi i konserwacji (36 strony), Instrukcja instalacji (25 strony)

Drukuj stronę

GAS COOKTOP INSTALLATION INSTRUCTIONS

(For 30" Models with 4 Sealed Burners, And Optional Electric Built-In Oven Combination)

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing the cooktop.

2. Remove all packing material before connecting the

electrical supply to the cooktop.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

5. Note: For operation at 2000 ft. elevations above see

level, appliance rating shall be reduced by 4 percent

for each additional 1000 ft.

Important Note to the Consumer

Keep these instructions with your Use and Care Guide for

future reference.

IMPORTANT SAFETY

INSTRUCTIONS

Installation of this cooktop must conform with local codes

or, in the absence of local codes, with the National Fuel

Gas Code ANSI Z223.1—latest edition in the United

States, or in Canada, with the Canadian Fuel Gas Code,

CAN/CGA B149 and CAN/CGA B149.2.

This cooktop has been design certified by International

Approval Services (I.A.S). As with any appliance using

gas and generating heat, there are certain safety

precautions you should follow. You will find them in the

Use and Care Guide, read it carefully.

• Be sure your cooktop is installed and grounded

properly by a qualified installer or service

technician.

• This cooktop must be electrically grounded in

accordance with local codes or, in their absence,

with the National Electrical Code ANSI/NFPA No.

70—latest edition in the United States, or in

Canada, with the Canadian Electrical Code, CSA

C22.1 Part 1.

• The burners can be lit manually during an

electrical power outage. To light a burner, hold a

lit match to the burner head, then slowly turn the

Surface Control knob to LITE. Use caution when

lighting burners manually.

• Do not store items of interest to children in

cabinets above the cooktop. Children could be

seriously burned climbing on the cooktop to reach

items.

• To eliminate the need to reach over the surface

burners, cabinet storage space above the burners

should be avoided.

• Adjust surface burner flame size so it does not

extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

• Never use your cooktop for warming or heating

the room. Prolonged use of the cooktop without

adequate ventilation can be hazardous.

• Do not store or use gasoline or other flammable

vapors and liquids near this or any other

appliance. Explosions or fires could result.

The electrical power to the cooktop

must be shut off while gas line connections are

being made. Failure to do so could result in serious

injury or death.

Installing the Cooktop

A roll of foam tape is supplied and packed in the

literature package. Install the tape around the perimeter

of the metal flange of the burner box, at a distance of

1/4" from the outer edge. Apply the exposed adhesive

side of the tape against the metal flange (see figure

above). Remove the protective film from the

underside of the tape before inserting the cooktop

into the countertop opening.

NOTE: This tape seals the underside of the cooktop to

the counter. Do not remove this foam tape. This tape

prevents entry of air that may interfere with proper gas

combustion, and prevents liquids from leaking under the

cooktop.

Insert cooktop into countertop cutout so that full width of

tape seals to cutout edge. NOTE: To avoid injury and

product damage, only suspend cooktop from cutout by

means of cooktop metal flange. Never suspend cooktop

from cutout by means of cooktop glass edges.

Figure 2