Electrolux DI 8821 Instrukcja obsługi i instalacji - Strona 17

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Okap wentylacyjny Electrolux DI 8821. Electrolux DI 8821 20 stron.

• For extractor versions (13A), connect the other end of the exhaust

pipe to the flue.

For filter versions (13F), fit deflector F to the support and secure it to

the bracket supplied using 4 screws, then connect the exhaust pipe

to the connection ring located on the deflector.

• Fit the nuts with fixing hooks (14) supplied inside the top and bottom

sections of the flues at the rectangular slots. A total of 14 nuts must

be fitted.

• Join the two top sections of the flue to cover the support (15) so that

one of the slots on the sections is situated on the same side of the

control panel and the other on the opposite side. Screw the two

sections together with 8 screws and springs (4 each side- see the

plan diagram for joining the two sections - springs must be fixed

horizontally).

• Fix the top flue assembly to the support, near the ceiling, with two

screws (16 - one each side).

• Carry out electrical connection of control panel and bulbs (17).

•

Join the two bottom sections of the flue covering the support (18)

using 6 screws and springs (3 each side, see the plan diagram for

joining the two sections - springs must be fixed horizontally).

• Insert the bottom section of the flue in its seat so that it completely

covers the motor compartment and electrical connection box, then

ensure it from inside the hood using two screws (19).

• Apply the 2 tabs (20 - supplied) to cover the fixing points of the

bottom flue (CAUTION! THE BOTTOM FLUE TABS ARE THE

NARROWER AND SHALLOWER ONES).

The wider and deeper tabs are those used for the top flue, and must

be cut to size.

If necessary, slightly expand the tabs to ensure their adherence to

the flue.

• Turn the mains power on again at the central electrical panel and

check for correct hood operation.