Electrolux EECH6001S Podręcznik użytkownika - Strona 7
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Okap wentylacyjny Electrolux EECH6001S. Electrolux EECH6001S 8 stron.
Drukuj stronę2 To remove the metal grease filter:
Push it towards the back of the unit and
then pull it down and out.
Hand washing
Soak grease filters for about one hour in hot
water with a grease loosening cleaner, then
rinse off thoroughly with hot water. Repeat
the process if necessary. Refit the grease
filters when they are dry.
Dishwasher
Place the grease filters in the dishwasher.
Select most powerful washing programme
and highest temperature, at least 65ºC.
Repeat the process if necessary. Refit the
grease filters when they are dry. When
washing the metal grease filters in the
dishwasher, a slight discolouration of the
filter can occur. This does not have any
impact on the performance.
Clean the inner housing using a hand hot
solution only (never use caustic detergents,
abrasive powders or brushes).
To replace the light globes
1 Remove the filter frame.
2 Turn mains switch off before removing
the lamp. Replace with 40W maximum
E14 candle lamp.
WARNING:
F a i l u r e
instructions on cleaning the unit
and changing the filters will
cause a fire hazard.You are
therefore strongly recommended
to follow these instructions.
T h e m a n u f a c t u r e r d e c l i n e s a l l
responsibility for any damage to the
motor or any fire damage linked to
inappropriate maintenance or failure to
o b s e r v e
recommendations.
TECHNICAL SPECIFICATIONS
600mm model: EECH6001S
Height: 77x122cm
Width 60cm
Depth 50cm
Rated Voltage: 220 - 240Vac, 50Hz
Total Power : 350W
Max Air Flow: 800m³/hr
Noise Level Max: 71dB
Lighting: 2 x 40W (E14 candle lamp)
Length of cable: 1mt
900mm model: EECH9001S
Height: 77x122cm
Width 90cm
Depth 50cm
Rated Voltage: 220 - 240Vac, 50Hz
Total Power : 350W
Max Air Flow: 800m³/hr
Noise Level Max: 71dB
Lighting: 2 x 40W (E14 candle lamp)
Length of cable: 1mt
TROUBLESHOOTING
If the hood fails to work properly, please
carry out the following checks:
The hood will not start:
1 Check that the hood is connected to the
electricity supply.
2 Check that the fan speed has been
selected.
7
t o
o b s e r v e
t h e
a b o v e
t h e
s a f e t y