Andrew James Bread Maker 17 Functions Instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wypiekacz do chleba Andrew James Bread Maker 17 Functions. Andrew James Bread Maker 17 Functions 20 stron. Bread maker 17 functions
Drukuj stronę
Use of an extension cord with this appliance is not recommended. However if it
is necessary to use an extension cord, ensure that the extension cord is equal to
or greater than the power consumption of the appliance to avoid overheating of
the appliance and extension cord. Do not use any other appliance on the
extension cord. Do not place the extension cord in a position where it can be
pulled on by children or animals or be tripped over.
Always operate the appliance on a smooth, even and stable surface. Do not place
the unit on a hot surface.
Always remove the plug of the appliance safely. Do not pull on the appliances
cord to remove the appliance plug from the electrical socket.
Never handle or operate the appliance with wet hands.
Appliance specific safety instructions
Do not place the appliance near hot gas/electric burners or in a heated oven.
Do not touch any moving or spinning parts of the machine while it is in
operation.
Do not switch on the appliance if the bread pan is not positioned correctly, or if
the bread pan is not filled with ingredients (except for the initial burning off of
substances left on during the manufacturing process).
Do not beat the top or the edge of the bread pan to remove the bread as this
may damage the bread pan.
Metal foils or other materials must not be inserted into the bread maker as this
can cause a fire or short circuit the appliance.
Never cover the bread maker with a towel or any other materials. Heat and
steam must be able to escape freely. A fire can be caused if it is covered by or
comes into contact with combustible material.
Do not use the appliance outdoors.
The appliance has been incorporated with a grounded plug. Please ensure the
wall outlet in your house is well earthed.
Do not touch the hot surfaces of the appliance during operation.
4
Electrical information
Please note:
It is extremely important that the wires or cores in the flex are connected to the
correct terminals in the plug. If the colour of the mains lead of the appliance does not
correspond with the coloured markings identifying the terminals in your plug proceed
as follows:
The Live (Brown) wire
connects to the right-
most live (L) terminal
nearest to the fuse.
The Neutral (Blue) wire
connects to the left-most
neutral (N) terminal.
The Earth (Green and
Yellow) wire connects to
the central, top most
earthed (E) terminal.
Warning:
If the appliance is double insulated indicated by the double insulated symbol:
it should not have an earth wire or earth connection.
Plug
The plug must be protected by the correct AMP fuse; this will be indicated on the case
of the plug. Only BSI or ASTA approved fuses should be used. When changing the fuse
always replace it with a fuse that is of the same identical rating as the original. If you
are unsure about which plug or fuse to use, always refer to a qualified electrician.
Please note after replacing the fuse, ensure that the cover is correctly fitted back onto
the plug. Never attempt to run the appliance if the plug does not have a cover. If a
moulded plug is fitted and has to be removed take great care in disposing of the plug
and severed cable, it must be destroyed to prevent it from engaging into a socket.
If the supply cord is damaged it must be replaced by a service agent or a similarly
37