Bosch 6 Series Instrukcje instalacji i użytkowania - Strona 5

Drukuj stronę

Bosch 6 Series Instrukcje instalacji i użytkowania

Installing the appliance

Transporting

The appliance is heavy. Secure in position during

transportation and installation.

Due to the weight/dimensions of the appliance and

to minimise the risk of injury and damage to the appli

ance at least two persons are necessary to set-up the

appliance safely.

Removing the appliance doors

If the appliance will not fit through the house door,

the appliance doors can be unscrewed.

Caution!

Only Customer service may unscrew the appliance

doors.

Installation location

Install the appliance in a dry, well ventilated room. The

installation location should neither be exposed to direct

sunlight nor near a heat source, e.g. a cooker, radiator,

etc. If installation next to a heat source is unavoidable,

use a suitable insulating plate or observe the following

minimum distances to a heat source:

3 cm to electric or gas cookers.

30 cm to an oil or coal-fired cooker.

If installing the appliance next to another refrigerator or

freezer, ensure a minimum lateral distance of 25 mm

to prevent the formation of condensation.

If a panel or cupboard is installed above the appli

ance, ensure that a gap of 30 mm is left so that the

appliance can be pulled out of the recess if required.

The air heated on the rear side of the appliance must

be allowed to escape unhindered.

Subsurface

Caution!

The appliance is very heavy.

The floor of the installation location must not give way;

if required, reinforce floor.

To ensure that the doors can open all the way, observe

lateral minimum distances when installing the appliance

in a corner or recess

(~ chapter "Installation dimensions").

If the depth of the adjacent kitchen equipment is more

than 60 cm, observe lateral minimum distances in

order to utilise the full door opening angle

(~ chapter "Door opening angle").

Observe ambient temperature and

ventilation

Ambient temperature

The climate class can be found on the rating plate. The

climate class indicates within which ambient temperat

ures the appliance can be operated. The rating plate

is located in the refrigerator compartment at the right

side.

Climate class

Permitted ambient temperature

+10 °C to 32 °C

+16 °C to 32 °C

+16 °C to 38 °C

+16 °C to 43 °C

Note:

The appliance is fully functional within the room

temperature limits of the indicated climatic class.

If an appliance of climatic class SN is operated at

colder room temperatures, the appliance will not be

damaged up to a temperature of +5 °C.

Ventilation

In order to improve efficiency of the cooling system and

save energy, it is necessary to maintain good ventila

tion around the appliance for the dissipation of heat.

For this reason, sufficient clear space should be avail

able around the refrigerator. Suggest: It is advisable for

there to be 50-70 mm of space from the back to the

wall, at least 100 mm from its top, at least 100 mm

from its side to the wall and a clear space upfront

to allow the freezer door to open 130° and the

refrigerator door to open 135°.

100 mm