Atlantic MD550 Instrukcja obsługi produktu - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi produktu dla Pompa wodna Atlantic MD550. Atlantic MD550 17 stron. Md-series
Również dla Atlantic MD550: Instrukcja obsługi (6 strony)
Drukuj stronę
• CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
• WARNING:
RISK OF ELECTRIC SHOCK - THIS PUMP IS SUPPLIED WITH A GROUNDING CONDUCTOR AND
GROUNDING-TYPE ATTACHMENT PLUG. TO REDUCE THE RISK OF ELECTRIC SHOCK, BE CERTAIN
THAT IT IS CONNECTED ONLY TO A PROPERLY GROUNDED, GROUNDING TYPE RECEPTACLE.
Electrical Safety
• Electrical wiring should be installed by a qualified electrician in accordance with all
applicable safety regulations. Incorrect wiring can lead to a pump malfunction, electrical
shock or fire.
• Pumps should operate on a designated, 110/120 volt circuit.
• Pump must be protected by a ground fault circuit interrupter (GFCI).
• Pump must be plugged into a standard, properly grounded, three pronged outlet.
Safety Instructions
• Do not lift, lower or handle the pump by pulling on the electrical cord. Make sure the
electrical cable does not become excessively bent or twisted and does not rub against a
structure in a way that might damage it. (Fig. 1)
• Always disconnect the power supply before doing any maintenance or placing your hands
into the water to which this pump is immersed. (Fig. 2)
• The submersible pump should not be used if the electrical supply cable is damaged in any
way. If a cable with damaged insulation is submerged in water, there is danger of water
seeping into the pump motor and causing a short. The electrical cable cannot be replaced.
If the cord is damaged, the pump should be discarded. Altering the electrical cable in any
way will void the warranty. (Fig. 3)
ATTENTION
Operation
• Mag Drive Series pumps are for use in water only. Water temperature should never
exceed 95˚ F (35˚ C).
• Mag Drive Series pumps must not be used to pump salt water, sewage, flammable or
corrosive liquids, greases, oils or food waste.
• Pay careful attention to the water level while the pump is operating. The pump must be
fully submersed at all times of operation.
Make sure the pump works at a proper water level. Do not
operate the pump without water. If so, the pump should be
turned off immediately and check.
Fig. 1
Fig. 2
Fig. 3
3