Dri-Eaz Dragon K85 Mobile Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piec Dri-Eaz Dragon K85 Mobile. Dri-Eaz Dragon K85 Mobile 20 stron. Dri-eaz dragon k85 mobile furnace owner's manual
Również dla Dri-Eaz Dragon K85 Mobile: Instrukcja obsługi (14 strony)

Drukuj stronę

2. Slide one of the heat shields over the ducting until it

rests against the Dragon housing. This will provide

extra protection against burns from accidental

contact with hot surfaces near the duct rings.

Slide the heat shields in place

3. Grasp the free end of the ducting and pull until it

reaches the structure. Take care not to damage the

aluminum ducting, as this could restrict airflow

during operation and cause the unit to shut off from

thermal overload.

4. Repeat steps 1 through 3 for the other length of

ducting. Always connect both lengths of ducting from

the Dragon to the affected area.

Securing ducting to the structure

In most drying situations you will need to attach the end

of the ducting to an opening in the structure such as a

basement window or crawlspace vent hole. Since each

structure is unique, you will usually need to build an

adapter to fit the specific opening.

To build two adapters, you will need:

2 Plywood sheets

2 Duct adapters, 8-inch diameter

2 Hose clamps

1 Jigsaw

1. Cut a sheet of plywood to fit over the opening in the

structure.

2. Use a jigsaw or similar tool to cut an 8-inch diameter

hole in the center of the plywood.

3. Fit an 8-inch diameter duct adapter (available at

most hardware stores) into the hole in the plywood.

Secure the duct adapter to the plywood.

4. Slip a hose clamp (not included) over the free end of

one of the 30-foot lengths of 8-inch diameter

aluminum ducting. Slide the ducting over the adapter

and secure firmly with the hose clamp.

5. Secure the plywood to the structure.

07-00407 E 08/2006

6. Repeat steps 1 through 4 for the second length of

aluminum ducting. Always connect both lengths of

ducting from the Dragon to the affected area.

Connecting the remote thermostat

The thermostat monitors the temperature in the affected

area. It turns the Dragon on and off to maintain a preset

temperature in the affected area.

Always operate the Dragon with the remote thermostat

connected. The HEAT switch will not function and the

Dragon will not heat the air if the thermostat is not

connected.

The remote thermostat sensor cable, control box, cable, and jack

1. Run the thermostat's 8-foot sensor cable into the

affected area. If necessary, drill a small hole in the

plywood adapter.

2. Position the tip of the sensor cable as far away as

possible from the Dragon process air—at least six

feet for best results.

Note: Only the tip of the sensor cable will read

temperature.

3. Place the thermostat control box where it will be

easy to monitor temperature setting. The control box

is weatherproof and may be left outside.