Atlantic Technology T70 Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Głośniki do kina domowego Atlantic Technology T70. Atlantic Technology T70 8 stron. System t70 high performance ultra-compact home theater loudspeaker system

Drukuj stronę

You can connect your T70 speakers by using a variety of audio connectors such as pin connectors,

spade lugs, etc., or you can:

1. Remove 1/2" of insulation from each wire end.

2. Twist the stranded wire together, keeping the two conductors separate.

3. Place the appropriate conductor through the appropriate postholes in the connectors. These holes are

revealed when you loosen the connector capscrew.

4. Screw down the capscrew tightly, but be careful not to over tighten.

5. Check the tightness of the capscrews 24 hours after hookup and occasionally thereafter, as they can

loosen over time.

We recommend that you check your local electrical codes to make sure that you are not using an

improper connector.

Figure 1:

Gold plated

5-way binding

posts. Accepts

up to 10 gauge

bare wire

When you're done hooking up your T70 system the wiring should look like the diagram in Figure 2.

Warning: Before turning on the amplifier, be certain that no stray wire strands are touching across any

terminals as this might damage your amplifier.

Finally, check the polarity of your front speakers by listening to some music. If the sound seems hol-

low, unusually spread out, or has weak bass, recheck your connections for proper polarity and reverse

any out of phase connections, if necessary. Usually one speaker wired out of phase is the culprit.

Placement and Operation

Speaker/room interactions have a huge impact on the sound of the system. Moving the speakers just a

little bit can make a dramatic difference in what you hear. The ultra-compact design of T70 provides

you with maximum placement flexibility, while creating a large, seamless, acoustically accurate

soundfield for your home theater or music system. The best placement of the speakers will vary from

room to room. Use the following placement guidelines and Figure 3 as a starting point. But also feel

free to experiment. In fact, it may be beneficial to hook up the speakers with some extra wire and to

simply drape the wire across the floor before installing the speakers permanently. This will allow you

the opportunity to move the speakers around easily so you can find the best sonic and visual locations.

Home Theater

Remember that the primary goal of a good home theater isn't to make you believe that you are in a

movie theater. It's to make you believe you are in the scene taking place on the screen. For a home

theater system, optimum placement of your T70 LR speakers is 2 to 3 feet to either side of the

television and 1 to 2 feet out from the wall, at ear height when seated. The left and right front speakers

should be far enough apart that you get a good stereo image, but not so far apart that the sound seems

to come directly from the speakers, distracting you from the picture. You may choose to "toe" the LR

It's important to observe polarity while making speaker connections: red (+)

terminals on the amplifier to red (+) on the speaker, black (–) on the amplifier

to black (–) on the speaker. Look carefully at the wires you are using and note

that one of conductors of each pair will be identified by color, printing on the

outer jacket, ridges on the outer jacket, or a thread intertwined with the wire

strands. By convention, the marked wire is connected to the red (+) terminal.

Atlantic Technology