Atlantic Ultraviolet Sanidyne Prime 40-0673A Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria Atlantic Ultraviolet Sanidyne Prime 40-0673A. Atlantic Ultraviolet Sanidyne Prime 40-0673A 16 stron. Ultraviolet portable area sanitizers

Drukuj stronę
Atlantic Ultraviolet Sanidyne Prime 40-0673A Instrukcja obsługi
SANIDYNE
PRIME OPERATION
®
K
C
eyPaD
ontroller
1.
Treatment Time: Displays chosen treatment time which will countdown after start is selected. Flashes with word "PREP"
during Countdown Time, the word "RUN" during Treatment Time and "DONE" when Treatment Time is completed.
2.
Hour Buttons: Up and down buttons are used to select treatment hours between 0 and 24.
3.
Minute Buttons: Up and down buttons are used to select treatment minutes between 0 and 59.
4.
Start Button: Begins treatment time countdown.
5.
Power Indicator: Glows RED when power is applied to unit and will flash during Treatment Time.
u
K
C
sing the
eyPaD
1.
Treatment time on the Sanidyne
Setting Treatment Time on the Keypad is done using the HOURS and MINUTES buttons which are located on the front of
1.
the unit. (See Figure 2 for location) Selecting the up or down facing arrows located on the keypad in line with the HOURS
or MINUTES button will either increase or decrease the hours or minutes. The hours can be set between 0 and 24, and the
minutes can be set from 1 to 59. (Example of one hour and five minutes would appear as 01:05 on the Treatment Time Display).
2. Determining the proper treatment times for your specific location can be done by using the "Recommended Treatment Time
for Room Size" chart (Figure 3 on Page 10).
3.
Once the choice of time has been displayed on the Keypad Controller, select the START button to begin and leave the
Operation Area immediately.
Once you select the START button an audible exit alarm will begin to sound and the Sanidyne
down from 1:30 seconds to allow all inhabitants to leave the area before the UV treatment begins. Additionally the word
"PREP" will begin flashing on the Keypad.
Under no circumstances should this sanitizer be permitted to operate with humans or animals present in
the Operation Area. DO NOT return to the Operation Area until the set treatment time has expired.
t
u
o
esting
nit
Peration
IN ORDER TO PERFORM THIS TASK, WEAR PERSONAL PROTECTION EQUIPMENT; GLOVES,
LONG SLEEVE SHIRT WITH NO GAPS BETWEEN CUFFS AND GLOVES, AND AN ULTRAVIOLET
BLOCKING FACE SHIELD MUST BE WORN TO COVER AND PROTECT EYES AND EXPOSED SKIN.
1.
Confirm cover is installed and 3 latches engaged. Although the cover must be fitted before testing the Sanidyne
operator must also put on the safety face shield as an extra precaution.
2.
Connect the power cord, plug into appropriate power source.
3.
Turn power on using the Power Switch located on the rear of the Sanidyne
Figure 1 - View C-C). Switch will glow RED when power is on. The POWER indicator located on Keypad Controller should
also illuminate.
4. Use the HOURS and MINUTES buttons to set the treatment time to display a short time, such as 00:02 (2 minutes).
5. Press the START button. The audible alarm will beep. (Continued on Page 10)
o
verview
Figure 2 – Timer Configuration
t
ontroller to set
Prime is controlled by the Keypad Controller (Shown in Figure 2).
®
t
reatment
imes
Prime (See Power Switch location shown on
®
Prime will begin counting
®
Prime, the
®
9