Drill Master 69487 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sander Drill Master 69487. Drill Master 69487 12 stron. 6" compact palm polisher
Również dla Drill Master 69487: Instrukcja obsługi i instrukcje bezpieczeństwa (13 strony)

Drukuj stronę

Maintenance and Servicing

procedures not specifically explained in this manual must

be performed only by a qualified technician.

TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:

Make sure that the power Switch is in the off-position and unplug the tool from

its electrical outlet before performing any procedure in this section.

TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:

Do not use damaged equipment. If abnormal noise or vibration occurs,

have the problem corrected before further use.

cleaning, Maintenance, and Lubrication

1. BEFORE EAcH USE, inspect the general

condition of the tool. Check for:

• loose hardware,

• misalignment or binding of moving parts,

• damaged cord/electrical wiring,

• cracked or broken parts, and

• any other condition that may

affect its safe operation.

2. AFTER USE, wipe external surfaces

of the tool with clean cloth.

Page 10

For technical questions, please call 1-800-444-3353.

3. Remove the Waxing/Polishing Bonnets from the

Pad when the Waxer/Polisher is not in use. This will

allow the Pad to dry and retain its original shape.

4. To prolong Pad life and shape, store

the Polisher with the Pad face up.

5. The Waxing/Polishing Bonnets may be

machine washed in cold water with detergent.

Then machine dry at medium heat.

WARNING! If the supply cord of this

power tool is damaged, it must be replaced

only by a qualified service technician.

Item 69487