ADVANCED Network Devices IPSCM-RM Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla System głośników ADVANCED Network Devices IPSCM-RM. ADVANCED Network Devices IPSCM-RM 2 stron.

IPSCM-RM
Version 1.4
Installation Instructions
IPSCM-RM-BB Assembly (Optional)
1. Remove knockout from desired location in IPSCM-RM-BB backbox.
2. Bend up 4 horseshoe tabs on IPSCM-RM-CB bridge until they are perpendicular to bridge surface
(Figure "C").
3. Run wiring, and conduit if necessary, through the knockout and make proper connections to the
speaker and/or circuit board.
4. Push snap-on tie off straps through holes in rim of IPSCM-RM-BB backbox (where required).
5. Secure IPSCM-RM-BB back box to IPSCM-RM-CB bridge by inserting horseshoe tabs through the
appropriate slots in the back box and twist with pliers (see Figure "C").
Figure C
IPSCM-RM-DB Assembly for Sheetrock Ceilings
1. Cut out an 8-1/2" diameter hole in the ceiling where the IPSCM-RM speaker is to be installed.
2. Insert two IPSCM-RM-DB dry wall clips onto the IPSCM-RM speaker studs at opposite ends of the
speaker that do not contain a threaded nut (see Figure "D"). Secure the clips to the baffle using the
two #8-32 nuts provided in the bag attached to the speaker magnet.
3. Make proper connections to the board or speaker per the IPSCM-RM-CB instructions.
4. Holding a clip temporarily open, slide one side of the unit into the ceiling cavity, then slowly
release the clip. Open the second clip and slide the remainder of the assembly into the cavity and
release the clip to secure the assembly to the ceiling surface. Use caution when handling and
opening the clips as they contain sharp edges.
Figure D
For additional support, visit
www.anetdsupport.com