Atlas TSD-PA252G Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Atlas TSD-PA252G. Atlas TSD-PA252G 8 stron. 2x25w global audio amplifier
Również dla Atlas TSD-PA252G: Instrukcja obsługi (8 strony)

Drukuj stronę

2x25W Global Audio Amplifier

Rear Panel Description

TSD Input/Output connections are removable for easy system wiring. The connectors have a 3.5mm

pitch between pins.

1. DC Power Input

external 24VDC power supply (sold separately). Because of the TSDs low power consumption, a

on current requirements in milliamps to match with the appropriate power supply. Please observe

the polarity of the wiring to this connector. Note: It is acceptable to exceed the current

requirements of the TSDs but NOT safe to use a power supply that is below the current

requirement of the device. When using an 8 speaker load, use a power supply with 1000mA

capacity. For 4 speaker loads, use a power supply with at least 2000mA capacity

2. Balanced Line Inputs L & R - Connect balanced line level signals to these left and right phoenix

style connectors. Your connection must be mated properly to the input connector or signal loss

and/or noise may occur. Note: Unbalanced line level inputs can also be used by connecting the

(G) and (-) terminals together.

3. RCA Inputs L & R - Unbalanced audio signals applied to these female RCA connectors are

controlled from the front panel L & R control knobs.

4. Speaker Outputs L & R - Connect the loudspeaker wiring to these terminals, observing the polarity

shown on the rear of the chassis. When in stereo mode, a polarity reversal on one channel will

load across the left speaker output (+) terminal and the right (+) speaker output terminal. The Left

wiring instructions.

5. Cable Management Retainer Points - Use the rear panel screws for connecting the included cable

AtlasSound.com

TSD-PA252G

– 4 –

Specifications are subject to change without notice.

Owner's Manual

speaker

Note: