Atlas DAGNY Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wentylator Atlas DAGNY. Atlas DAGNY 10 stron. Ceiling mounted rotational fan

Drukuj stronę

MOU NTING/INSTALLATION

OF THE FAN

Before touching

a screw driver thoroughly

read these instructions.

Warning/Caution:

Before installing fan, turn off

power at service panel and check all visible

screws and bolts for tightness.

1. Remove the decorative canopy bottom cover

from the canopy by turning the cover counter

clockwise. (Fig. 5)

2. Remove the hanger bracket from the canopy

by removing the 1 of 2 screws from the

bottom of the hanger bracket and loosening

the other one a half turn from the screw head.

Next, turn the canopy counter clockwise to

removing

the hanger

canopy. (Fig. 5)

3. Secure the hanger bracket to the ceiling outlet

box using screws and washers included with

your outlet box. (Fig. 6)

4. Remove hanger ball from down rod assembly

by loosening set screws, removing the cross

pin and sliding ball off rod. (Fig. 7)

5. Loosen the two set screws from the central

shaftftop coupling of the motor assembly.

Doing so will allow the down rod to enter the

central shaft. (Fig. 8)

6. Carefully feed the fan wires through the down

rod and pull them taut. Thread the down rod

into the central shaft and tighten well.

Re-tighten the set screws against the down

rod.

7. Slide the coupling cover (with wide end

oriented to floor) down the down rod. Tighten

the set screws of the coupling cover so that it

is secure in its new position.

8. (Fig. 8)

NOTE: Make sure that coupling

cover has at least 1/8" to 1/4" clearance

between it and fan motor assembly. If this

clearance

is not given, the fan will not

rotate.

9. Slide canopy ring (with decorative

oriented to floor) and canopy (with wide end

oriented to ceiling) onto down rod. Carefully

reinstall hanger ball onto rod. Be sure that

cross pin is in correct position, the set screw

on hanger ball is tight and that the wires are

not twisted.

bracket

from the

side

~:~~~~

,,~

bracket

~ \_.

J"-;:~I~~~

•

;

(',

.•l.......--Canopy

cover

Figure 5

":",-Washers

Mountmg

(supplied

120V Wires

electrical

Figure 6

....-Cross

~ ..

Hanger ....--.~

fl~screw

ball

~DownrOd

Figure 7

"'-Canopy

Figure 8

screws

with

box)

ring

Set screws