Atlas 700 Series Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Stojaki i stojaki Atlas 700 Series. Atlas 700 Series 12 stron. Floor-standing cabinets
Drukuj stronę100, 200, 500, 700, & FMA Series
iv. Mount a caster on each caster installation point by using the ¼-20 KEPS nuts to finally attach both the metal stiffener bracket and the
caster.
e. FMA Series cabinets:
i.
Locate the (4) caster installation points on the metal truck bracket.
ii.
Each caster mounts to the inside skirt of the metal truck bracket.
iii. Use sixteen (16) of the provided
nuts to attach each caster.
iv. Fit the metal truck bracket to the bottom of the cabinet.
v.
Use ten (10) of the provided
to attach the assembly to the cabinet. Make sure the head of the carriage
bolt on the outside of the cabinet and the nut will be on the inside of the
cabinet.
11. Side Panel Installation
DID YOU KNOW? Open frame cabinets can be fully enclosed by adding door and side panels. Side panels are sold in pairs. Therefore, a single pair of
side panels can be used to help enclose a single cabinet or a large group of ganged cabinets.
a. SPS Series Side Panels for 500 and 700 Series cabinets:
i.
Simply hang the side panels onto the cabinet frame by engaging the six side panel hooks into the six slots found on the side of the
cabinet.
ii.
For simple key lock security, the SP-LOCK may be purchased separately. Follow instructions provided.
iii. If key lock is not sufficient then the provided #8 sheet metal screws may be driven into the side panels through the holes found in the
rear door flange.
Front of Cabinet
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
Floor-Standing Cabinets
⁄
-20 x .625" carriage bolts and
1
4
⁄
-20 x .625" carriage bolts and
⁄
1
1
4
⁄
-20 KEPS
1
4
-20 KEPS nuts
4
TELEPHONE: (800) 876-3333
FAX: (800) 765-3435
Back of Cabinet
AtlasSound.com
6/12