Atlas Copco D2160-Q Instrukcje dotyczące produktu - Strona 15

Przeglądaj online lub pobierz pdf Instrukcje dotyczące produktu dla Wiertarka Atlas Copco D2160-Q. Atlas Copco D2160-Q 20 stron. Straight drill

Drukuj stronę
Atlas Copco D2160-Q Instrukcje dotyczące produktu
D2160-Q

Troubleshooting

Troubleshooting
The table describes the most common problems, possible reasons and how to fix them. Note that some
actions must be carried out by authorized workshops or qualified service technicians.
Problem
Free speed is too slow, pressure
never reaches the target.
The tool has been in contact with
water.
The tool does not start.
Inconsistent idling speed.
Low power
Tool starts unexpectedly
Vibrations
The motor housing istoo hot.
Abnormal sound
*) This service must only be carried out by authorized workshop or qualified service technician.
EN
Possible reason
Too low air flow in the pressurized
air system.
The pressurized air system con-
tains condensed water.
No air flow to the tool.
Motor jammed.
Unstable air pressure.
Worn governor (LBB45).
Low air pressure.
Wrong lenght or dimension of air
supply hose.
Blocked filters.
The humidity in the air is high.
Too much grease in the gear box.
Worn throttle valve
Worn vanes/motor?
Worn governor (LBB45)
Damaged throttle valve
Valve pin jammed in start position.
Worn or damage drill bit.
Too much grease in the gear box.
Not enough grease in gear hous-
ing.
Damaged gear.
Worn motor bearings.
© Atlas Copco Industrial Technique AB - 9839 1477 01
Troubleshooting
Action
Shorter hose to the FRL unit and/or
larger diameter is needed. See In-
stallation proposal for more infor-
mation.
See Service recommendations for
specific environments.
Make sure that the air connection
is correctly set.
*
Make sure that the air pressure
regulator is working correctly.
*
Make sure that the air pressure is
correctly set.
Make sure that the air connection
is correctly set.
Clean or change the corse and fine
filter
Make sure that the compressor is
working correctly.
Make sure that the amount of
grease is correct.
*
*
*
*
Change pin and guide
Change drill bit
Make sure that the amount of
grease is correct.
Make sure that the amount of
grease is correct.
*
*
15