Bose Panaray LT 9402TM WR Instrukcja serwisowa - Strona 19
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Głośniki Bose Panaray LT 9402TM WR. Bose Panaray LT 9402TM WR 27 stron. Weather resistant
Drukuj stronę
DISASSEMBLY PROCEDURES
3. Input Panel Assembly Removal
3.1 Remove the twelve screws (11) that
secure the input panel assembly (12) to the
cabinet. Lift the assembly away from the
cabinet. Disconnect the cables that plug into
the PCB. Lift out the assembly.
4. Compression Driver Removal
4.1 Remove the twelve screws (11) that
secure the input panel (12) to the cabinet. Lift
off the rear panel. The gasket should remain
adhered to the cabinet.
4.2 Make a note of the wiring configuration,
and disconnect the wires from the compres-
sion driver. Remove the four screws (14) that
secure the Compression Driver (15) to the
cabinet. Lift the compression driver out of the
cabinet.
5. V2 Two Assembly Removal
5.1 Remove the four screws (10) that secure
the V2 assembly (8) to the cabinet. These
screws are located at the four corners of the
assembly. Do not remove the other screws
around the casting. Carefully lift the assem-
bly out of the cabinet. Make a note of the
wiring configuration, and disconnect the two
wires from the connector.
Model 9402
TM
WR Loudspeaker
Note: Refer to Figure 9 for the following
procedures.
1. Grille Removal
1.1 Remove the fourteen screws (1) that
secure the grille assembly (3) to the cabinet.
1.2 Lift the grille assembly off of the cabinet.
The gasket should remain adhered to the
cabinet.
2. Logo Removal
2.1 Remove the grille using procedure 1
above.
2.2 On the back of the grille, carefully re-
move the slotted washer that retains the
spring and spacer against the back of the
grille. Note the direction the spacer faces.
Slide the spring and spacer off of the logo
post.
2.3 Lift the logo off of the grille.
3. Input Panel Assembly Removal
3.1 Remove the twelve screws (11) that
secure the input panel assembly to the
cabinet. Lift the assembly away from the
cabinet. Disconnect the cables that plug into
the PCB. Lift out the assembly.
4. Compression Driver Removal
4.1 Remove the twelve screws (11) that
secure the input panel (12) to the cabinet.
Lift off the rear panel. The gasket should
remain adhered to the cabinet.
4.2 Make a note of the wiring configuration,
and disconnect the wires from the compres-
sion driver. Remove the four screws (14)
that secure the Compression Driver (15) to
the cabinet. Lift the compression driver out
of the cabinet.
5. V2 Two Assembly Removal
5.1 Remove the four screws (10) that
secure the V2 assembly (8) to the cabinet.
These screws are located at the four
corners of the assembly. Do not remove the
other screws around the casting. Carefully
lift the assembly out of the cabinet. Make a
note of the wiring configuration, and discon-
nect the two wires from the connector.
19