Atlas Copco Secoroc YSP 45 Stoper Instrukcja obsługi/lista części zamiennych - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi/lista części zamiennych dla Wiertarka Atlas Copco Secoroc YSP 45 Stoper. Atlas Copco Secoroc YSP 45 Stoper 20 stron. Rock drill
Drukuj stronę
Note! Do not bend the drill steel as this will increase wear of the shank bushing and
piston. It can also affect drilling efficiency and increase the risk of drill steel
breakage.
Stopping the stoper
Pull the throttle lever upwards, which will stop percussion, rotation and flushing
water.
Blow-cleaning the drill hole
CAUTION
When blow-cleaning, particles and dirty flushing water can emerge at speed from
the drill hole.
h
Move to the side and cover your eyes before starting to blow-clean the drill
hole.
h
Always wear impact resistant eye protection with side protection to avoid
injury.
Make sure that no co-workers are in range when blow-cleaning.
h
If powerful blow-cleaning of the drill hole is required, turn the throttle lever fully
upwards whereupon the stoper stops. This can be done during drilling. When the
drill hole is clean, turn the throttle lever downwards again to re-start the stoper.
When you have finished drilling
Run the stoper at medium speed when retracting the drill steel from the drilled
hole.
Lay down the stoper on a stone, wooden plank or similar object, so as to prevent
drill cuttings and other foreign matter from entering the chuck.
Turn off the water pressure before the air pressure. Run the stoper for a few
seconds to clean out water and moisture after the water has been shut off.
Maintenance
Regular maintenance is a prerequisite for machine safety. Replace damaged and
worn components in good time.
Check the machine and drill steel for wear and damage at regular intervals. Do not
use a very worn or damaged drill steel.
When cleaning mechanical parts with a solvent, make sure that you comply with
current health and safety regulations and ensure that there is sufficient ventilation.
Daily maintenance, regular checking of wearing parts and carrying out repairs in
good time prevents breakdowns and increases the service life of the machine.
h
Make sure that no foreign matter enters the machine.
h
Always hose down and wipe clean the stoper after use.
Once a shift (after 8 hours of operation)
h
Check the wear in the chuck bushing. If the wear limit has been exceeded, the
drill steel shank will wear more quickly, or become deformed. This will lead to
stoppages and increased drill steel consumption.
h
Check the hoses, couplings and controls for leakage and damage.
h
Check that the stoper is receiving enough lubrication. Fill the lubricator if
necessary.
10