Atlas Copco Secoroc YSP Series Instrukcja obsługi/lista części zamiennych - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja obsługi/lista części zamiennych dla Wiertarka Atlas Copco Secoroc YSP Series. Atlas Copco Secoroc YSP Series 20 stron. Rock drill
Drukuj stronę
h
Every day before using the drill, blow out the air hose to clear it from
accumulated dirt and moisture.
h
Drain the water separator.
h
Check the air and water pressure. Make sure that the water pressure is at least 1
bar lower than the air pressure.
Once a week (after 40 hours of operation)
Carry out a basic check of all functions of the drilling equipment.
Once a month (after 200 hours of operation)
h
Send the stoper to a workshop for inspection. The local operating conditions will
determine whether or not this is a suitable interval for overhauling the drill.
h
Dismantle and clean the lubricator.
h
Clean out the water separator.
Selection of spare parts
Use only genuine parts for replacement, to ensure stable performance. Do
not use pattern parts, which not only have a short working life but also cause
consequential damage to other parts, due to differing measurements and methods
of manufacturing.
Storage
h
Always oil the stoper well before you put it into storage.
Store the stoper in a clean and dry place.
h
h
In the case of long-term storage, pour a quantity of oil directly into the stoper's
air intake and then turn on the air briefly. This will protect the machine from
corrosion.
h
Protect the chuck using a wooden plug or a clean piece of cotton waste.
Scrapping and waste disposal
Used and worn-out machines must be disposed of in such a way that as much of
the material as possible can be recycled and the impact on the environment is kept
to a minimum.
11