Atlas Copco G2427 S250 Instrukcje dotyczące produktu - Strona 5

Przeglądaj online lub pobierz pdf Instrukcje dotyczące produktu dla Szlifierka Atlas Copco G2427 S250. Atlas Copco G2427 S250 12 stron.

G2427 S250

Correct working with the die grinder

Read the Section Safety instructions before using the die grinder.

WARNING Failure to follow correct working practices can result in serious injury or death

Ensure that the workpiece is properly supported

►

Ensure that sparks do not cause a hazard to people or materials

►

There is a risk of electrostatic discharge if the tool is used on plastic and other non-conductive

►

materials

Personal protective equipment must be used as described in Section Personal protective equip-

►

ment

Slip/Trip/Fall is a major cause of serious injury or death. Watch out for excess hose left on the

►

walking or work surface

Proceed with care in unfamiliar surroundings. Hidden hazards may exist, such as electric or other

►

utility lines

Maintain a balanced body position and firm footing

►

React quickly to excessive vibration due to damaged, or improperly mounted insert tool

►

Keep away from rotating drive spindle and abrasives. Rotation may continue for several seconds

►

after the throttle has been released. Do not lay the tool down until rotation has stopped

Observe that stored compressed air in the hose may cause an accidental start

►

Release control device if the energy supply should fail

►

Maintenance

Rust protection and internal cleaning

Water in the compressed air, dust and wear particles cause rust and sticking of vanes, valves etc.

This can be solved by lubricating with oil (a few drops), running the machine for 5-10 seconds and wiping

off excess oil with a cloth. Do this before longer standstills.

Lubrication

The front motor ball bearing should be lubricated with grease in conjuction with the regular overhaul of the

machine.

For flexible spindle extension – When fitting the extended spindle – apply 0.5 cm

cating Engineers LE3752" (or EP grease) at the bottom of the hole in the collet holder.

Lubricating guide

Use lubricants of good quality. The oils and greases listed in the lubrication table are examples of lubri-

cants that can be recommended.

Safety and operating instructions

of grease type "Lubri-