Bose CineMate GS Series II Instrukcja obsługi - Strona 24
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Bose CineMate GS Series II. Bose CineMate GS Series II 38 stron. Digital home theater speaker system
Również dla Bose CineMate GS Series II: Lista kodów (28 strony), Podręcznik szybkiej konfiguracji (2 strony), Instrukcja obsługi (50 strony), (Angielski) Podręcznik użytkownika (32 strony)
Drukuj stronę
TAB 8
TAB 7
C
I
ONTROLS AND
NDICATORS
Using the remote to control the
CineMate
®
system
When you point the remote control at the interface
module and press the Power, Volume, or Mute button,
the green LED on the interface module flashes.
Press On-Off to turn on the CineMate speaker
system. Press again to turn the system off.
Press Volume + to raise the volume. When
maximum volume is reached, the green LED on
the interface module flashes twice.
Press Volume – to reduce the volume. When
the minimum volume is reached, the green LED
on the interface module flashes twice.
Press Mute to silence the audio. Press again to
restore the audio. When the system is muted,
the green LED on the interface module flashes
until audio is restored.
The universal remote can also be programmed to control
up to five audio/video devices and will control the
functions of one device at a time.
24
TAB 6
TAB 5
TAB 4
TAB 3
Setting the remote for your TV and
other devices
To use the remote with your TV, you must set the remote
for the proper TV device code.
1. Locate the TV section in the Universal Remote
Device Codes book.
2. Locate the device code(s) for your brand of TV and
start with the first one.
3. Press and hold Setup on the remote until all five
source buttons light up.
4. Press the TV source button. Only the TV source
button will remain lit.
5. On the remote keypad, enter the first device code
for your brand of TV.
6. Check that the TV source button blinks twice and
turns off after the code is entered.
7. Point the remote at your TV and press TV On-Off.
If your TV does not respond, go back to Step 1 and
try another code.
Note: During programming, the five source buttons will
flash rapidly three times if you press an invalid key or enter
an unavailable device code. If this happens, go back to
Step 1 and start over.
TAB 2
English