Bose L1 ToneMatch II Instrukcja obsługi - Strona 17
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System głośników Bose L1 ToneMatch II. Bose L1 ToneMatch II 32 stron. System with tonematch port
Drukuj stronę
English
English
Dansk
Deutsch
Español
Dansk
Setting up the L1
Figure 4
Putting the power stand on
the floor
Assembling the L1 model II Cylindrical Radiator
Figure 5
Setting up the L1 model II
Cylindrical Radiator
®
loud-
speaker top and bottom
Français
Deutsch
Italiano
Nederlands
Español
TM
model II power stand
1. Holding the power stand vertically on the foor (Figure 4A), grasp one leg and swing it out
as far as it will go. Notice that the other legs swing out automatically. The legs must be
fully open before you can plug the L1
2. Lay the power stand flat on the floor in the desired position (Figure 4B).
A
Socket for
L1 bottom
WARNING: DO NOT move the completely assembled system as a unit. This could result in
personal injury and/or damage to the product. Position the power stand on the floor in the
chosen location before assembling the system.
This procedure tells you how to set up the loudspeaker sections in the power stand. If you
plan to mount the T1 ToneMatch
ToneMatch
TM
audio engine (optional)" on page 12 before installing the top section of the loud-
speaker.
1. Hold the L1 bottom so that the grille faces front and plug it into the power stand (Figure
5A). Be sure to fully insert it into the socket to assure stability and a good connection.
2. Align the bayonet on the L1 top with the channel on the back of the L1 bottom, and lower
the L1 top onto the L1 bottom until it is flush (Figure 5B).
A
Front of
system
Français
Svenska
TM
bottom section into the power stand.
®
loudspeaker
TM
audio engine on the L1 model II system, see "Adding a T1
B
L1 top
L1 bottom
Italiano
Nederlands
B
Bayonet
Channel
Svenska
S
S
YSTEM
ETUP
9