Bose PANARAY LT II Series Instrukcja serwisowa - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla System głośników Bose PANARAY LT II Series. Bose PANARAY LT II Series 18 stron.
Drukuj stronę
DISASSEMBLY/ASSEMBLY PROCEDURES
Note: Numbers in parentheses correspond
to the item call outs in Figure 1.
1. Compression Driver Removal
1.1 Disconnect the Neutrik Speakon™
connector(s) and the weather protector, (if
used).
1.2 Disconnect the red and black wires (6)
from the compression driver terminals.
Note: On some models, the connectors
may have been soldered.
1.3 Remove the four screws (4) holding
the compression driver assembly (3) to the
cabinet.
1.4 Remove the four screws holding the
compression driver (2) to the mounting
plate.
2. Compression Driver Replacement
2.1 Place the new compression driver on
to the mounting plate, and secure it to the
plate.
2.2 Place the compression driver assem-
bly (3) on to the cabinet and secure it to
the cabinet.
Note: Tighten screws in the following
order: clockwise with a torque setting of 5
inch-pounds. Counter clockwise with a
torque setting of 15 inch-pounds. Clock-
wise with a torque setting of 25 inch-
pounds.
2.3 Reconnect the red and black wires (6)
to the terminals on the driver.
2.4 Perform the test procedures on page
13.
2.5 Reconnect the Neutrik Speakon
connector to the speaker panel and re-
place the weather protector, (if used).
3202™/4402™/9702™ SERIES I
10
3. M-10 Driver Removal
3.1 Perform procedure 1.1.
3.2 Remove the bottom two screws (5) on
the connector panel (7).
3.3 Loosen the two top screws on the
connector panel. This will allow room for
the M-10 driver when lifting it out of the
cabinet.
3.4 Remove the four screws (8) holding
the M-10 driver (1) to the cabinet.
Note: Do not let the driver fall out of the
cabinet.
3.5 Disconnect the green and white wires
(10) from the M-10 driver.
4. M-10 Driver Replacement
4.1 Reconnect the green and white wires
onto the new M-10 driver.
4.2 Place the new M-10 driver (1) onto the
cabinet, carefully routing the green and
white wires around the side of the driver.
4.3 Secure the M-10 driver to the cabinet.
4.4 Replace the two screws (5) in the
bottom of the connector panel, and tighten
all four screws.
4.5 Perform procedure 2.4 and 2.5.
Note: To remove the lower M-10 driver (9)
from the model 3202 simply remove the
four screws (11) holding the driver to the
cabinet, and disconnect the speaker wires.