Advanced Radio I Charger Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka Advanced Radio I Charger. Advanced Radio I Charger 9 stron.

Step 6

Next to the slider switch on each Charge Port You will see a

LED

and a

RED

LED. The blue LED is a charge indicator and the red

LED is a fault indicator. These LEDs have the following meaning.

BLUE LED FLASHING =

The charger is connected to a 12 volts sup-

ply but has no battery connected.

BLUE LED SOLID =

The charger is in the battery charging process.

BLUE LED OFF =

The charge has finished the main charge process

and is in trickle charge mode.

RED LED SOLID =

There is a battery fault. This could be:

1) Battery over temperature (if using the optional temperature

probe). The charge process will stop until the battery returns to

the safe temperature range.

2) A bad battery that still has a low voltage after 23 minutes of

startup charge and cannot be charged.

3) A 3 hour period has been reached and the battery is still not

completely charged.

Step 7

BLUE

To start the charging process it is a simple process of connecting

a 12volt power supply. As soon as you connect the 12 volt supply

the AR Logo is shown for a brief moment, the charger boards are

reset and (if batteries are connected) the charge process begins.

You should see similar to the picture below if using a 3 port charge

and have all 3 ports connected to batteries.

Note. As with all chargers you need to be present during the

charge cycle. DO NOT LEAVE UNATTENDED. If you must leave

note the capacity of charge into the battery(s) then disconnect

the 12v source to stop the charge. Resume when you return by

simply plugging the barrel plug back in.