3M HEADSET C1060 Informacje o usłudze - Strona 15
Przeglądaj online lub pobierz pdf Informacje o usłudze dla Zestawy słuchawkowe 3M HEADSET C1060. 3M HEADSET C1060 18 stron. Wireless intercom system
Również dla 3M HEADSET C1060: Podręcznik z listą części zamiennych (14 strony), Podręcznik programowania (5 strony)
Drukuj stronę
Wireless Intercom System
Interconnect Module
An interconnect module is needed when a Headset
Intercom System includes an auxiliary intercom to
provide continued communications when the primary
intercom needs service.
The auxiliary intercom may be a conventional,
hard-wired intercom or it may be a second base
station.
External system components (speakers, microphone,
vehicle detector) connect to interconnect module
connector J302. Base station inputs and outputs
(power, common, menu mic, menu speaker, vehicle
detector) connect to interconnect module connector
J303. Auxiliary intercom (or second base station)
inputs and outputs connect to interconnect module
connector J301.
On/Off DC
In the interconnect module schematic diagram, the
interconnect module is shown in its "off" state, with
relays de- -energized.
On/Off control of the interconnect module is provided
by (the presence or absence of) +12VDC from the
(primary) base station. With base station +12VDC
present (via J303 pins 1 and 2), relays K301, K302
and K303 energize to switch microphone, speaker and
vehicle detect signals to/from the base station. If the
base station-provided DC is not present (base station
turned off), relays K301, K302 and K303 de-energize
to switch the same signals to/from the auxiliary
intercom.
Menu Microphone Signal Control
Relay contacts K301-A and K301-B control
distribution of the menu mic signal(s). With relay
K301 energized, the menu mic is connected to the
base station inputs. With Relay K301 de-energized,
the menu mic is connected to the auxiliary intercom.
E 3M 2003
March
Theory of Operation and Diagrams
Menu Speaker Audio Control
Relay contacts K302-A and K302-B control
distribution of the menu speaker audio. With relay
K302 energized, the menu speaker is connected to the
base station. With relay K302 de-energized, the menu
speaker is connected to the auxiliary intercom.
Monitor Speaker Audio Control
Relay contacts K303-B control distribution of monitor
speaker audio. With relay K303 energized, the drive
side of the monitor speaker is connected to the
monitor speaker output of the base station. With relay
K303 de-energized, the drive side of the monitor
speaker is connected to the monitor speaker output of
the auxiliary intercom. Monitor speaker common is
not switched.
Vehicle Detector Signal DC
While the vehicle detector is powered separately (if it
is a "presence" type detector), vehicle detector signal
DC is always provided by both the base station and
the auxiliary intercom. This vehicle detector signal
DC is available at interconnect module connector
J302-9.
A vehicle detector signal DC of +12VDC is provided
by the base station at J303 pins 9 and 10. A vehicle
detector signal DC of +18VDC is provided by the
auxiliary intercom at J301 pins 1 and 7.
If both the auxiliary intercom and the base station are
ON, the vehicle detector signal will always be
+18VDC because the auxiliary intercom's +18VDC
will take precedence over the +12VDC supplied by
the base station. (Isolation of the two DC sources is
provided by interconnect module diodes D301 and
D303.) If only the base station is ON, the vehicle
detector signal DC will be +12VDC.
1- -11