Bose Acoustimass 3 Series Instrukcja serwisowa - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla System stereo Bose Acoustimass 3 Series. Bose Acoustimass 3 Series 42 stron. Powered speaker system
Również dla Bose Acoustimass 3 Series: Instrukcja obsługi (17 strony), Instrukcja obsługi (10 strony), Podręcznik (43 strony)
Drukuj stronę
3. Twiddler Removal
A. Remove the 4 screws (4) holding the twiddler
(3) in place. Lift the twiddler out and cut the wires
connected to the twiddler as close to its terminals
as possible.
4. Twiddler Replacement
A. Strip the wires and connect to the replacement
twiddler (3).
NOTE: The positive (+) terminal of each twiddler
is marked with a red dot.
B. Connect the red wire to the positive (+)
twiddler terminal and the black wire to the
negative (-) twiddler terminal.
C. Lower the twiddler into the satellite enclosure
and secure the twiddler to the enclosure with 4
screws (4). Repeat the satellite test procedures.
5. Terminal Cover Removal
NOTE: There are catches on the top and bottom
(inside) of the terminal cover (7) that hook it into
the satellite enclosure. Take care when removing
the cover.
A. Using your fingers or the flat edge of a
screwdriver,pull the terminal cover carefully from
the satellite enclosure using the recesses in the
cover.
6. Terminal Cover Replacement
A. Snap the terminal cover (7) carefully into place
on the satellite enclosure.
7. Connector Removal
A. Remove 2 screws (4) which hold the
connector in place.
8. Connector Replacement
A. Secure the connector (6) to the satellite
enclosure with 2 screws (4).
17