Bose Wave Radio Instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Bose Wave Radio. Bose Wave Radio 16 stron. Owner's guide
Również dla Bose Wave Radio: Instrukcja obsługi (20 strony), Instrukcja obsługi (12 strony), Podręcznik szybkiej konfiguracji (1 strony), Instrukcja obsługi (27 strony), Instrukcja obsługi (26 strony)

Drukuj stronę

For your safety

1. Read, Follow And Save All Instructions – Read and follow the complete safety and operating

instructions in this owner's guide before using the unit. Save this guide for future reference.

2. Pay Attention To Warnings – Observe all warnings on the unit and in the guide.

3. Do Not Let Objects Or Liquid Enter The Unit – Take care to prevent objects or liquids from

entering this unit. Do not use near a bathtub, washbowl, kitchen sink, laundry tub, in a wet base-

ment, near a swimming pool, or anywhere else that water is present. Clean only as directed on page

13.

4. Maintain Proper Ventilation – Place the unit so nothing interferes with its proper ventilation. Do not

place on a bed, sofa, or similar surface that may block the ventilation openings. Do not put it in a

bookcase or cabinet that may keep air from flowing through its ventilation openings.

5. Avoid Excessive Heat – Do not place the unit near heat sources such as radiators, stoves, or other

appliances (including amplifiers) that produce heat.

6. Use Proper Power Sources – Plug the unit into a proper power supply, as described in the

operating instructions or as marked on the unit. This unit has a polarized alternating current line plug

(one blade is wider than the other). As a safety feature, the plug fits into the power outlet only one

way. If you have trouble inserting it, reverse the plug. If it still does not fit, your outlet may be

obsolete and needs to be replaced. Contact an electrician. Do not change the plug to defeat this

safety feature.

7. Protect The Power Cord – Route all power cords so that they are not likely to be walked on or

pinched. Pay particular attention to cords at plugs, at the point where the cord connects to the unit,

and at outlets on the unit.

8. Take Precautions When Unit Is Not In Use – If the unit will not be used for an extended period,

unplug from the outlet and remove the batteries.

9. Be Careful With Carts And Stands – Do not place this unit on an unstable cart, stand, tripod,

bracket, or table. The unit may fall, causing serious injury to a person or damage to the unit. For

advice on use of a particular cart, stand, tripod, bracket, or table, contact Bose

10. Avoid Power Lines – Do not install external antennas near overhead power lines or other electric light

or power circuits, nor where an antenna can fall into such circuits or power lines.

11. Ground All Outdoor Antennas – If an external antenna or cable system is connected to this unit, be

sure the antenna or cable system is grounded. This will provide some protection against voltage

Ground

Clamp

Electric

Service

Equipment

12. Obtain Authorized Service When It Is Indicated – Do not attempt to service this unit yourself. All

servicing should be provided by authorized service personnel when:

A. The power supply cord or the plug has been damaged, or

B. Objects have fallen or liquid has spilled into the unit, or

C. The unit has been exposed to rain, or

D. The unit does not appear to operate normally or exhibits a marked change in performance, or

E. The unit has been dropped or the cabinet damaged.

AM149204_02_V.pdf

surges and built-up static charges.

Section 810 of the National

Antenna

Electrical Code ANSI/NFPA No. 70

Lead In Wire

provides information with respect to

proper grounding of the mast and

supporting structure, grounding of

Antenna

the lead-in wire to an antenna

Discharge Unit

(NEC Section 810-20)

discharge unit, size of the ground-

ing conductors, location of

Grounding

Conductors

antenna-discharge unit, connection

(NEC Section 810-21)

to grounding electrodes, and

Ground Clamps

requirements for the ground

Power Service Grounding

Electrode System

electrode. Refer to the antenna

(NEC ART 250 Part H)

grounding illustration.

January 7, 2002

Safety Instructions

Corporation.

If you must move the unit and cart

combination, do so very carefully.

Quick stops, excessive force, and

uneven surfaces may cause it to

overturn.

Note to CATV system

installer:

This reminder calls the CATV

system installer's attention to

Article 820-40 of the NEC (of

USA) that provides guidelines for

proper grounding. It specifies that

the cable ground shall be

connected to the grounding

system of the building, as close to

the point of cable entry as is

practical.