23zero SABER Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Namiot 23zero SABER. 23zero SABER 12 stron.

SABER USER MANUAL

Out of the box, some hardware must be fitted to the Saber tent. Hinges, gas struts and locks

are all pre fitted. Hardware is fitted to the Saber via the channels on the edges of the roof lid

and baseboard. Insert 1 x square slide nut per hex bolt in the channel and slide to the required

position. Insert hex bolts through the mounting holes on the hardware and line these up with the

square slide nuts. Rotate hex bolt clockwise to locate thread. Once located slide the hardware to

the desired position and tighten with a 5mm Allen or Hex key.

The handle should be fitted centred at the rear of the Saber (non hinge side)

Locate desired entry point as this will determine the position of the ladder brackets. Position the

ladder brackets approx.. 430mm apart in the centre of the desired entry point.

Tip: Temporarily remove the horizontal bar on the ladder bracket to better access the hex bolts.

Note: If using a side entry, the bottom half of the lock mechanism will need to be temporarily

These are to be fitted at the rear 115mm in from the corners of the bottom baseboard.

This is a twist lock pole which must be fitted when tent is in use. Position this right hand side of

Fitting hardware

Handle: (Roof lid)

Ladder brackets: (Baseboard)

removed to allow the ladder brackets to slide past.

Stay pole brackets: (Baseboard)

Safety pole: (Inside - when tent is in use)

high end (inside tent looking out).