Bose SoundDock Series II Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Konwerter mediów Bose SoundDock Series II. Bose SoundDock Series II 32 stron. Digital music system
Również dla Bose SoundDock Series II: Instrukcja obsługi (17 strony)
Drukuj stronę
English
TAB 2
1. Read these instructions – for all components before using this product.
2. Keep these instructions – for future reference.
3. Heed all warnings – on the product and in the owner's guide.
4. Follow all instructions.
5. Do not use this apparatus near water or moisture – Do not use this product
near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a
swimming pool, or anywhere else that water or moisture are present.
6. Clean only with a dry cloth – and as directed by Bose Corporation. Unplug
this product from the wall outlet before cleaning.
7. Do not block any ventilation openings. Install in accordance with the
manufacturer's instructions – To ensure reliable operation of the product and
to protect it from overheating, put the product in a position and location that
will not interfere with its proper ventilation. For example, do not place the
product on a bed, sofa, or similar surface that may block the ventilation open-
ings. Do not put it in a built-in system, such as a bookcase or a cabinet that
may keep air from flowing through its ventilation openings.
8. Do not install near any heat sources, such as radiators, heat registers,
stoves or other apparatus (including amplifiers) that produce heat.
9. Protect the power cord from being walked on or pinched, particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.
10. Only use attachments/accessories specified by the manufacturer.
11. Use only with the cart, stand, tripod, bracket or table speci-
fied by the manufacturer or sold with the apparatus. When a
cart is used, use caution when moving the cart/apparatus
combination to avoid injury from tip-over.
12. Unplug this apparatus during lightning storms or when
unused for long periods of time – to prevent damage to this
product.
TAB 3
TAB 4
TAB 5
TAB 6
Important Safety Instructions
13. Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way: such as power supply
cord or plug is damaged; liquid has been spilled or objects have fallen
into the apparatus; the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped – Do not attempt to ser-
vice this product yourself. Opening or removing covers may expose you to
dangerous voltages or other hazards. Please call Bose to be referred to an
authorized service center near you.
14. To prevent risk of fire or electric shock, avoid overloading wall outlets,
extension cords, or integral convenience receptacles.
15. Do not let objects or liquids enter the product – as they may touch
dangerous voltage points or short-out parts that could result in a fire or
electric shock.
16. See product enclosure for safety related markings.
17. Use proper power sources – Plug the product into a proper power source,
as described in the operating instructions or as marked on the product.
Information about products that generate
electrical noise
If applicable, this equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
this is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, you are
encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the antenna in the device receiving the interference.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a different circuit than the one to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This product complies with the Canadian RSS-310 Class B specification.
TAB 7
TAB 8
iii