Bose PS1 Instrukcja obsługi - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Bose PS1. Bose PS1 28 stron.

Figure 8

Using a serial effects

connection

Using a serial effects connection with the PS1 power stand

Note: Connecting an effects unit in serial requires a TRS split "insert" cable (with a ¼-inch TRS

connector on one side, and two mono ¼-inch phone connectors on the other). This type of cable

is readily available at most musical instrument stores and on the Internet.

1. Insert the TRS plug into the Channel 1 Insert jack on the PS1 power stand.

2. Connect the ¼-inch mono plug (labeled "send", "ring", or "right") to the input of the

effects processor.

3. Connect the other ¼-inch mono plug (labeled "return", "tip", or "left") to the output of the

effects processor.

4. Adjust the effects level and mix of the effects processor.

Note: A very high output from the effects processor can overload the input of the PS1 power

stand. If the LED on the remote turns red, even if the channel LEVEL control on the R1 remote

control is below the 12 o'clock position, reduce the output level of your effects processor.

Note: The effects processor does interrupt the audio path. This may result in no audio output if

the effects processor is turned off. To use a "clean" signal, do not turn the effects processor off,

but put it in bypass mode.

TRS split "insert" cable

Connect to

Channel 1 Insert

PS1 power stand

TRS

(Return, Left or Tip)

Connect to Effects Unit

OUTPUT

Digital Effects Unit

Operating Instructions

(Send, Right, or Ring)

Connect to Effect Unit INPUT