Bose Lifestyle 35 Series II Instrukcja instalacji - Strona 36

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Zestawy słuchawkowe Bose Lifestyle 35 Series II. Bose Lifestyle 35 Series II 42 stron. Noise cancelling
Również dla Bose Lifestyle 35 Series II: Instrukcja instalacji (36 strony), Instrukcja obsługi (25 strony), Instrukcja obsługi (24 strony), Instrukcja obsługi (13 strony), Podręcznik szybkiej konfiguracji (3 strony), Instrukcja obsługi (46 strony), Instrukcja obsługi (36 strony), Instrukcja obsługi (32 strony), Skrócona instrukcja obsługi (2 strony), Przywracanie ustawień fabrycznych (2 strony), Skrócona instrukcja obsługi (2 strony), Instrukcja obsługi (38 strony)

Drukuj stronę

Bose Lifestyle 35 Series II Instrukcja instalacji

PTIONAL

ONNECTIONS AND

Other jacks on the media center panel

Figure 33

Additional jacks on the

media center rear panel

DDITIONS

There are other, optional connections you can make as needed.

Antenna extender

IR Emitter

Serial Data

Antenna extender as an option

If your remote control does not communicate with the media center, but the batteries are still

good, you may need extended transmission range. Use an antenna extender, which may be

purchased at an authorized Bose

IR emitter cable as an option

You can set your LIFESTYLE

it or to the media center. An IR signal sent from the media center to the

component makes this additional control possible.

If a component does not respond to the LIFESTYLE

IR (infrared) signals may not be reaching it.

For greater assurance that the IR signals reach the target component while you are setting

the remote to control the component, use the optional IR emitter. After the control is set up,

you may not need to continue using the emitter. Or keep it connected for use with one

component, as needed.

Note: For information on how to set the LIFESTYLE

Operating Guide.

To use the emitter:

1. Insert the 3.5 mm plug at one end of the cable into the IR Emitter jack on the media

center panel.

2. At the other end of the cable, place the rounded surface near the component.

3. Move the emitter around, as necessary, to find the best position.

4. Use the double-sided tape enclosed with the emitter to affix it in position near the

component.

Note: If you have questions, need to obtain a replacement emitter, or want to purchase an

add-on IR emitter (Part Number 277896-001), which can work with up to three components,

contact Bose Customer Service. Refer to the address list included in the carton.

Data port

Some systems will have a data port for future use.

Serial data jack

This jack is for factory and service use only.

Français

Media center connector panel

dealer and plugs into the media center.

remote to control your TV and other components connected to

system remote control commands, the

remote to control the TV, refer to your

Español

English

Data port