Drongo VoiceAlert Instrukcja obsługi
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System bezpieczeństwa Drongo VoiceAlert. Drongo VoiceAlert 2 stron.
Drukuj stronęICONS IN THIS MANUAL
ANTENNA
CONNECTION
POINT
POWER SLIDE SWITCH
MICROPHONE
POWER / MESSAGE LED
LINK LED
1 - POWER
Plug in AC adapter into the back of the Voice Alert.
Move the 'Power slide switch' to the ON/ I
position. The
/Power LED and the
Charging LED should glow indicating that the
device is on and charging.
When the
LED glows, the battery is full
and you can unplug the device.
3 - INSTALL
Screw supplied antenna to the antenna connection
point until finger-tight.
Place your Drongo Voice Alert in a location suitable
to the following requirements: Up to 300 meters line
of sight from sensors and up to 50 meters indoors
(through walls) Adjust the Volume dial /
your voice messages will be heard.
info@drongo co za
www.drongo.co.za
SENSOR LOW BATTERY LED
BATTERY CHARGING LED
BATTERY FULL LED
PLAYBACK BUTTON
2 - RECORD
To record a voice message, move the slide switch into the
/Record position.
/Battery
Select the Zone "1" button, hold it down and record your
message by speaking clearly into the
The
held down. Your message can be no longer than 6 seconds.
Repeat the previous steps to record a message for Zones
2-6. To hear your message, slide the switch into the
/RUN position and select the Zone number you would like
to playback.
To record a Low Battery reminder, move the slide switch
into the
button, record your desired notification into the
and then return the switch to the
The
/Link LED will only glow while being held down.
To test the 'Low Battery reminder', press the Playback button
for 2 seconds.
so that
. .
VOLUME ADJUSTER
RUN
RECORD
LINK MODE
1-6
ZONES BUTTONS
/Link LED will only glow while the desired Zone is
/'Record' position and hold in the
/RUN position.
+27 87 094 1218
7 Gert Kotze Street
Springbok Park, Brackenfell CPT
/MIC .
/Playback
/MIC