DROPSA 3135121 Instrukcja obsługi i konserwacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Systemy smarowania DROPSA 3135121. DROPSA 3135121 14 stron. Chain lubrication & dispensing
Drukuj stronę
6. UNPACKING AND INSTALLING Vip4chain
6.1 UNPACKING
Once a suitable location has been found to install the unit remove the unit from the packaging. No particular disposal
procedures are necessary, however packing should be disposed of in accordance with regulations that may be in force
in your area or state.
6.2 INSTALLING THE UNIT
Allow sufficient space around the unit for ease of maintenance. Install at a suitable level for refilling the oil reservoir.
Do not install in aggressive environments. Fix the unit using the two fixing holes and 6mm screws.
6.3 ELECTRICAL WIRING
Before carrying out any wiring, ensure that the correct power supply is available. Refer to the identification label on
the unit and this instruction manual.
6.4 INSTALLING THE MICROPUMPS ONTO THE BASE MODULE
Normally, you will order a unit already pre-configured with the correct number of micropump and base modules. In
the event these need to be altered or changed, the pumps can be removed by taking out the 2 fixing screws as shown
on the diagram bellow. Ensure to place the three O-Rings correctly when installing a new pump module.
6.5 ADDITING OR REMOVING A SUBBASE.
The bases must always be added or removed from the bottom one first. To add or remove a sub-base from the
Vip4chain unit
1. Disconnect power and air suppl and empty the tank (by removing the unit and pouring out the oil into a
container)
2. Disconnect the solenoid valve on the base of the unit using the three fixing screws.
3. Remove the End-plate by undoing the two fixing screws
4. Add a new sub-base (or remove the existing one) as shown in the diagram below. Ensure the Electrical
connector and O-rings are all in place before closing the sub base against either another sub-base or the end-
plate
5. Add the end-plate and the solenoid valve.
Electrical
Connector
Push-in
Fixing screws
Micropump
O-Rings
Mixing Sub
Base
Bleed screw
Threaded Insert
O-Seals
Bleed screw
Mixing Sub-Base
Plate
Fixing Screws
4