DROPSA K000455 Instrukcja obsługi i konserwacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Narzędzia DROPSA K000455. DROPSA K000455 8 stron. Battery operated high performance grease gun
Drukuj stronę
8. TROUBLESHOOTING
Below is a trouble shooting table to show possible problems and solutions.
If you are in any doubt about the correct solution to fixing a problem, do not dismantle parts of the Bravo but contact an
Authorized Dropsa Sales and Service Point for technical assistance.
PROBLEM
The motor will not run
Pressure relief valve opens when
grease is being delivered
Unit not pumping grease
The unit continually breaks of
delivery of grease
The battery is not taking a charge
9. MAINTENANCE PROCEDURE
The battery powered high performance grease gun requires no maintenance.
Make a regular check on the pressurised components (high pressure hose) and also on the live parts (charger) for possible
damage. Defective parts must be replaced with genuine spares without delay.
10. DISPOSAL
During maintenance or disposal of the machine care should be taken to properly dispose of environmentally sensitive items such
as oils or other lubricants. Refer to local regulations in force in your area. When disposing of this unit, it is important to ensure
that the identification label and all the other relative documents are also destroyed.
11. ORDERING INFORMATION
DESCRIPTION
GREASE GUN
12. HANDLING AND TRANSPORTATION
Prior to shipping, the equipment is carefully packed in cardboard package. During transportation and storage, always maintain
the pump the right way up as indicated on the box. On receipt check that package has not been damaged. Then storage the
machine in a dry location.
TROUBLESHOOTING TABLE
POSSIBLE CAUSE
The battery is flat or defective.
The wiring to the motor is defective
Lubricating nipple defective or
blocked.
Lubricating pipe defective or blocked
Bearing point defective or blocked
The grease gun container is empty.
The grease feed is interrupted
Due filling with loose grease there is
air trapped in the grease
No ,mains voltage to charger.
Battery defective or worn out
REMEDIAL ACTION
Charge or replace the battery.
Remove the battery, disassemble the
handle and check for loos
connections.
Check affected parts and if necessary
clean or replace
Check the level in the grease
container.
Bleed out the air
Empty the grease gun container and
bleed the air out of the refilled gun
Check whether the cosket is alive
Replace the battery.
PART NUMBER
K000455
5