anko LD-K3030A Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Czajnik anko LD-K3030A. anko LD-K3030A 9 stron. Cordless water kettle

anko LD-K3030A Podręcznik użytkownika
Warning - risk of burns / scalding
* Always place the water kettle on a solid and even surface.
Ensure that it cannot slip or be dropped and that the power cord does not hang down.
* The kettle becomes hot while in use. Do not move the kettle during operation and do not pull
on the mains cord. Only hold/lift the hot kettle by its handle.
* Contact with rising steam can cause scalding! Make sure the lid is always firmly closed and
do not open it while water is boiling or while pouring water out.
* Do not fill the container with less than (0.5 litres) or more than (1.7 litres) of water. If there is
not enough water in the kettle, the appliance may overheat.
* Be sure that the kettle is switched OFF before taking it off the power base.
* The kettle is only to be used with the stand provided.
* If the kettle is overfilled, boiling water may be ejected.
* The heating element and surfaces are subject to residual heat after use.
* WARNING – Avoid water spillage on the electrical connectors.
* WARNING – Potential injury from misuse.
* WARNING – Do not remove the lid while the water is boiling.
IMPORTANT!
* Take care that any steam escaping from the appliance cannot damage wall paper, wall
cabinets or other items. Turn the spout away from furniture and walls.
* Do not use caustic, aggressive or abrasive cleaning products for cleaning.
Keep hard items away from the appliance.
* Although the kettle is protected from boiling dry, it must never be operated without water.
* If the overheat cut-out switch switches OFF the kettle to prevent overheating and boiling dry,
proceed the follows:
- Remove the kettle from the base.
- Allow the kettle to cool down for at least 15 minutes before refilling it with water and replacing
the kettle back on the power base.
* Only use the kettle with the power base provided.