anko LD-K3078 Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Czajnik anko LD-K3078. anko LD-K3078 7 stron. Cordless water kettle

Unpacking

DANGER to children- danger to life due to suffocation/swallowing

Keep the packing material out of children's reach. Dispose of it immediately.

* Carefully remove all parts from the packaging and check that no parts are missing or possibly damaged.

* Remove all packaging material.

First time use

IMPORTANT! during the below process DO NOT fill the kettle more than the Min. (0.5L) mark

on the kettle. Filling above the Min. mark will cause over boil and spillage out of the spout.

To ensure a long service-life of the water kettle, proceed as follows before using it for the first

time:

1. Fill the kettle with water and add vinegar in a ratio of 1:3 (1part vinegar / 3 parts water).

2. Bring to a boil (see Boiling water), then pour away.

3. Allow the kettle to cool down and then refill it fresh water, boil the water and then pour it away.

To avoid scale deposits, descale the water kettle at regular intervals (after about every



15th use) as described in the section "Descaling".

Boiling water

WARNING: Risk of scalding from hot water

* The kettle and its lid become hot while in use. Do not touch them.

* The lid must be tightly closed during the boiling process. It must not be opened while pouring

out water. Allow the appliance cool down before opening the lid.

* Do not fill the water container with less than MIN. (0.5L) or more than MAX. (1.7L) of water.

1. Lift the lid with your hand to open it.

2. Fill the kettle with the amount of water required.

You can check the filling level on the indicator.

3. Press the front of the lid down firmly to close it.

Make sure that the lid is closed properly,



otherwise the water kettle may not switch OFF

after boiling.

Fully unwind the power cord and run it through the cable guide channel on the power base.

5. Plug the mains cable into an earthed socket that is within easy reach.

6. Place the kettle on the power base.

7. Set the On/Off switch to On (I).

The control blue lamp will light up to indicate that the kettle is ON.

When the water is boiling, the kettle switches OFF automatically

and the control blue lamp will go out.

8. If you wish to stop heating the water before it boils, set the

On/Off switch to Off (0).

WARNING: Risk of scalding from hot water

* Be sure that the water kettle is switched OFF before taking it off the power base.

9. After the water has come to a boil, wait a moment, until the water has stopped simmering.

--USE--