anko SL157C Podręcznik użytkownika - Strona 18

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Odkurzacz anko SL157C. anko SL157C 20 stron. For household use only

14 Troubleshooting

Noisy operation

Suction Not Strong

Over-heating / Stopping

Floor Brush hard to push

Static Shock

Clean the Filters and empty the Dust Canister

Check for partial blockages and unblock.

Clean the Filters and empty the Dust Canister.

Check for blockages and unblock

Check that the Suction Relief Valve on the hose handle

is closed.

Clean the Filters, empty the Dust Canister, check for

blockages and unblock then allow it to cool for

approximately 1 hour before trying to restart.

Due to the strong suction of your vacuum cleaner, it

may be difficult to push, especially over thick carpet.

Rather than forcing the Floor Brush, lift the Floor Brush

momentarily to allow air to flow into the vacuum

releasing the built-up suction pressure, then continue

vacuuming.

The Floor Head brush may be extended when using

on a carpet. Retract the brush.

Slide open the vacuum Suction Relief Valve located on

the hose handle. This will reduce suction to the floor

head.

In some rare instances, one or two users may feel an

electric discharge when touching or using the vacuum

cleaner during or after use. This is a well-known

phenomenon of Static Electricity discharge that

happens mostly when the user vacuums a synthetic

fibre carpet or other synthetic surfaces. It can also be

more prevalent in dry and cool environments. Although

the feeling of the Static Electricity can be unpleasant

for the user, it is not dangerous and is not a fault of the

vacuum cleaner. If this static discharge is a problem

for the user, the user could try wearing insulating

footwear during vacuuming (i.e. rubber or leather

soles), or increase the humidity / heat level in the

surrounding environment or both.

Page 18 of 20