anko BL1703A-SA Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Blender anko BL1703A-SA. anko BL1703A-SA 9 stron.

18. Do not use outdoors.

19. Keep hands and utensils out of the blending jug while blending to reduce the risk of

severe injury to persons or damage to the blender. A scraper may be used but must be used

only when the blender is not running.

20. To reduce the risk of injury, never place the cutter-assembly blades on the base without

attaching it to the jar properly.

21. Always operate the blender with the jar cover in place.

22. Warning: never use hot liquids or run the appliance empty.

23. Be care of potential injury from misuse.

24. Care must be taken when handling the sharp cutting blades, emptying the bowl and

during cleaning.

25. Always disconnect the appliance from mains power if it is left unattended and before

assembling, disassembling or cleaning.

26. Switch OFF the appliance and disconnect from mains power before changing

accessories or approaching parts that move in use.

27. This appliance is intended to be used in household and similar applications such as:

– Staff kitchen areas in shops, offices and other working environments;

– Farmhouses;

– By clients in hotels, motels and other residential type environments;

– Bed and breakfast type environments.

WARNING! Do not blend hot liquids. To prevent scalding, DO NOT process boiling

liquids or hot ingredients in the blender. Allow hot ingredients to cool down below 40

before placing them in the blender.

IMPORTANT!

To prevent damage to the electric motor, the maximum operating time is 1 minute.

Allow it to rest for at least 2 minutes before using it again. After 5 cycles of operation,

allow the blender (electric motor) to cool down to room temperature, allow it to cool

down for approx. 30 minutes before using it again.

Note: The appliance incorporated with a non-self resetting thermal motor protection

circuit to protect the motor from overheating. If the motor shuts OFF while in use,

unplug the unit from main power outlet. Remove the blending jar from motor unit and

free the blade of any obstructions. Allow the unit to cool down for at least 1 hour. After

then, plug the unit back into mains power for normal operation.