Elektra Beckum SKN 50 Instrukcja obsługi i konserwacji - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Pistolet do gwoździ Elektra Beckum SKN 50. Elektra Beckum SKN 50 8 stron. Elektra beckum finish nailer operating and maintenance instructions
Również dla Elektra Beckum SKN 50: (Podręcznik użytkownika i konserwacji (8 strony)
Drukuj stronę
3.2 Tool Safety
Air-powered tackers shall
only be operated and
serviced by persons having
been instructed in the
operation of such tools.
Keep out of the reach of
children.
Before every use check to
see that all safety and
triggering
devices
functioning properly. Also
check the tightness of all
screws and nuts. The tool
must not be modified, nor
shall any emergency repairs
or conversion be made.
Avoid damage or weakening
of the tool. Never dismount
or disable parts such as the
tool's trigger.
3.3 Work Safety
Never aim an operable
tacker against yourself or
other
persons.
When
working, hold the tacker in
such way that your head and
body will not be injured in the
event of possible recoil.
Never pull the trigger with the
nozzle in the air.
When the tacker is operable,
carry it at the handle only and
never with the trigger pulled.
When working, take care that
fasteners are not shot
through thin material and do
not slide off at corners or
edges.
Always wear safety glasses
and hearing protection when
working with a tacker.
4. Initial Operation
The tool must be discon-
nected from the air supply for
loading its magazine!
By pressing the catch lever
(item 4) the magazine is
unlocked and the magazine
slide (item 7) can be pulled
back. The nails can then be
loaded from the side. Push
are
magazine slide (item 7)
forward until it engages at the
catch lever.
Turn exhaust deflector (item
5) to desired position. Set the
working pressure to the
lowest recommended pres-
sure (4.0 bar). Connection to
the pressurised air source is
made by 6 mm flexible air
hose fitted with a quick
coupler. Set the tacker,
checked for proper functio-
ning, to the point the fastener
is to be driven and pull the
trigger (item 3).
The SKN 50 is fitted with a
protecting cap on the contact
trip, to prevent damage when
working planed or otherwise
finished surfaces. For special
applications the protecting
cap should be removed.
To access a nail jammed in
the tip, actuate the lever on
the side of the service shutter
(item 8) to open it, then
remove jammed nail.
Increase or decrease the
working pressure in 0.5 bar
increments, until the desired
result is achieved. The tacker
should be operated at the
lowest pressure possible.
Take care to avoid working
pressures over 7 bar and
shots without fasteners in the
magazine.
The SKN 50 features a depth
adjustment (item 6), which
allows for adjusting the depth
the nails are driven in.
A faulty or not properly wor-
king tool must be discon-
nected from the pressurised
air source immediately and
presented to a competent
person for inspection. Dis-
connect tool from air supply
and empty the magazine
during extended work breaks
or when work is completed.
5. Care and Maintenance
5.1 Care
Observing the maintenance
instructions given here en-
sures a long service life and
trouble-free operation of this
quality product. Always dis-
connect from the pressurised
air supply when servicing.
For a lasting, trouble-free
operation daily cleaning and
periodic lubrication is in-
dispensable. Use only
special pneumatic oil (see
chapter „Accessories").