Becom Argos3D-P23X Skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kamera 3D Becom Argos3D-P23X. Becom Argos3D-P23X 15 stron.
Drukuj stronęQuick Start Guide - Argos3D-P23X
Last change: 30 January 2019/Version 2
Note
Please follow the next steps in the right order to get your 'Argos3D-P23x' up and running
correctly.
1.3.1
Connecting the break-out board
Please connect the break-out board to the Argos3D-P23x common connector first.
1.3.2
Connecting the power supply
To ensure, that your Argos3D–P23x works correctly, connect the 'Argos3D' to a 12-30V DC power supply using
connector (a) and wait for approximately 20 seconds until the camera boots up.
Pin assignment on the power connector (a): Pin #1: +12V to +30V, Pin#2: GND
Note
The power supply connector is protected against wrong polarity but the 'Argos3D' will not
work in case you don't use the correct polarity! If the Argos3D–P23x doesn't work please
check the power supply polarity first!
© BECOM Systems 2019
Figure 1-2: Argos3D–P23x common connector
6 | 15