Druck DPI 841 Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt testowy Druck DPI 841. Druck DPI 841 14 stron. Frequency calibrator and frequency loop calibrator

Drukuj stronę

Operation

This section gives examples of how to connect and use the

instrument. Before you start:

• Read and understand the "Safety" section.

• Do not use a damaged instrument.

Operation - Frequency connections

To prevent instrument errors, make sure that the

frequency connections (A1-item [10]) are correct.

Operation - Communications port connections

Use the communications port (A1 - item [9]) to attach an

IDOS Universal Measurement Module (UMM).

When you attach the cable from a UMM (Figure 7/8), the

instrument automatically changes the menus to give you

all the applicable options (Table 2/3).

Operation - Measure Hz or count pulses

To measure Hz or count pulses:

1. Connect the instrument (Figure 1) and, if necessary,

adjust the Set Up (Table 1).

2. Select a Hz or Pulses input task from Select Task

(Table 2/3) and, if necessary, adjust the Settings

(Table 4).

3. For Pulses, use Start/Stop (■ ■) to start and stop the

count. The display shows the time (hh:mm:ss) since you

started the count.

Figure 1: Example configuration - To measure Hz

or count Pulses

- [EN] English

Pulses

Settings

Start

a) Hz

b) Pulses

Operation - Change the output values

When the output operation is set up (Table 5), use one of

these procedures to change the output values:

Table 7: Procedures to change the output

Output

Pulses

Example procedure ("Nudge" output):

Display:

Hz output

Sk1 = Edit

Sk2 = Settings

Display:

Hz output

Settings

Procedure

Select Edit (■ ■) and/or use the ▲ ▼ buttons.

See the example below.

Select Start/Stop (■ ■) or use the ▲ ▼ buttons

to make the step changes manually.

Select Start/Stop (■ ■).

Edit

■ ■

▲

1.010

1.020

▼

Increment = 0.010

(Table 5)

Edit

▲

+01.000

▼

K395 Issue 3