AirTest TR9277-EO-A Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria AirTest TR9277-EO-A. AirTest TR9277-EO-A 12 stron. Tr9277-eo series.

Drukuj stronę
5.

Linking the TR9277-EO Sensor to a Receiver

This process requires the controller or receiver to be mounted and powered and within range of the
TR9277-EO sensor to be linked.
The sensor is a solar powered device that absorbs energy through a solar panel storing it for use
during low light periods. Before assigning the sensor to a receiver/controller, the device must be
exposed to a good light source for a minimum of 2 hours, or
install the optional start assist battery (not supplied).
1.
Remove the sensor from the back plate by pressing in on
the tab on the bottom of the sensor and pulling away
from the back plate.
2.
Activate LEARN or LINK mode at the receiver, if
necessary refer to the manufacturers documentation.
3.
Press the temperature sensors Link (Teach) button.
4.
Deactivate LEARN mode at the receiver.

6. Using The Adjustment and Test Functions

The TR9277-EO uses a single button interface to allow installers and
users to make adjustments to the sensor and utilize built-in test
functions. Pressing the "function" button at the right side of the sensor
at different intervals allows navigation to different functions. Feedback
is provided by observing the color and sequence the LEDs at the side
of the solar panel (see section 3). A navigation chart is provided below
with more detailed instructions provided in the sections following.
TR9277-EO Manual
Page 6 of 12