Drummond 58009 Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Pompa wodna Drummond 58009. Drummond 58009 9 stron. 3/4 hp submersible sewage pump
Drukuj stronę
Operation
After reading these instructions, consider the following points before starting the pump:
Warning! Do not handle this pump, plug in, or unplug
this pump with wet hands or while standing in water.
Make sure all power has been turned off to the pump.
1. Make sure the pump is properly set up.
a. Verify that the pump rests on the floor of the basin.
b. Verify that the discharge pipe
is properly connected.
c. Verify that the electrical connection
is 120 VAC, 60 Hz.
d. Verify that the electrical socket is GFCI
protected and in good condition. Test
GFCI protected outlet before use.
e. Verify that water and moisture cannot
get near the power supply socket.
Maintenance
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Unplug the Pump from its electrical outlet before performing any
inspection, maintenance, or cleaning procedures.
If the pump is moved during operation, flush it out with clean water after every use.
Quarterly Maintenance
The below maintenance must be performed at least once every 3 months under optimal conditions.
For frequent use, or dirty areas, more frequent maintenance is required.
1. Clean sludge and debris from the bottom of the basin.
2. Clean sludge/debris from inlet screen.
3. Make sure discharge pipe is free from leaks.
4. Make sure check valve is functioning properly.
Item 58009
For technical questions, please call 1-888-866-5797.
f. Verify that the pump is installed so
as to prevent running dry.
2. Plug the Pump Cord into the Float Switch
Cord. Then plug the Float Switch Cord
into a GFCI protected outlet.
3. The pump will start operating when the
float switch moves up over the pump
top. Water will be pumped out.
4. When water lowers to a certain level, the
float switch will turn the pump off.
5. Motor is equipped with an automatically resetting
thermal overload protector. If motor gets too hot,
the overload protector will shut off pump before it is
damaged. When motor has cooled sufficiently, the
overload protector will reset, and the motor will restart.
5. Manually operate flow switch to determine
that pump turns on/off as intended.
Page 5